AMT HEATER HR-1 User Manual

Safety precautions.
CAUTION! There are no user serviceable parts inside. Repair of the device can be
carried out only by qualified experts. If the device is not used it must be
disconnected from mains.
WARNING! In order to avoid fire or electric shock the device must not be exposed to
rain or moisture. Do not let water or other liquid get inside the device. Do not place
vessels such as vases filled with liquid on top of the device.
Please read the instruction manual very carefully.
1. Keep the user's guide at hand.
2. Follow all instructions related to device operation.
3. To clean the device, use only a dry cloth having disconnected
the device from mains prior to that.
4. Do not place the device near heat sources, keep it from direct
sunlight.
5. Lay the mains cable so that it is not stepped on and avoid its
contact with sharp corners, etc. If you use the plug or outlet for
switching the device off they should be easily accessible.
6. Use only additional devices and accessories recommended by
the manufacturer.
7. Disconnect the device from mains in case of thunder-storm or
when the device is not in use for prolonged time.
8. All works related to the device repair must be done only by
qualified service personnel.
9. WARNING! All service instructions are intended only for
qualified personnel in order to avoid electric shock; do not
carry out any repair works which are not described in the
instruction manual. Repair works must be carried out only by
.
qualified experts
www.amtelectronics.com
www.amtelectronics.com
1
Contents
Important instructions
Complete set
General Characteristics
AMT HEATER HR-1 features
Before you start
Controls
Batteries installation
IMPORTANT INSTRUCTIONS!
NON-OBSERVANCE OF THE FOLLOWING INSTRUCTIONS CAN CAUSE
DAMAGE OF THE AMPLIFIER OR SPEAKERS. THE DAMAGES RESULTED
BY NON-OBSERVANCE OF
WARRANTY VOID.
After transportation or storage of the product under
negative temperatures, before switching the device on it is
necessary to leave the device under room temperature in
its original package for AT LEAST 2 hours!
To connect the guitar pedal to other devices use only the
cables intended for such connections.
You must not use other cables types such as speaker, etc.
SWITCHING ON the guitar pedal:
Switch the device on ONLY AFTER YOU HAVE DONE all
audio connections!
Before connecting the pedal to mains make sure that the
case, the connecting cable and the of the power adapter
have no damages such as cuts, cracks, dents, etc. and are
operational.
To switch the pedal on first insert the low-voltage
connector of the power adapter into corresponding jack of
the guitar preamp and only then plug the adapter into the
mains outlet.
SWITCHING OFF the guitar pedal:
To switch the pedal off first disconnect the power adapter
from mains and then disconnect its low-voltage connector
from the jack of the guitar pedal.
COMPLETE SET
The complete set includes:
1.
Guitar pedal HR-1
2.
Instruction manual
3.
Packaging
4.
Warranty card
www.amtelectronics.com
1
1
2
2
2
2
2
THESE INSTRUCTIONS MAKE
1
1
1
1
1
THE