Related Manuals for nanoplanes Shark
Summary of Contents for nanoplanes Shark
- Page 1 SHARK BUILDING INSTRUCTIONS Please review this entire manual before beginning assembly. Please visit our website www.nanoplanes.net for more information. This is not a toy. It is meant for use by the experienced Radio Control Hobbyist...
-
Page 2: Included Items
CONTENTS of the NANO SHARK KIT INCLUDED ITEMS All Depron Parts with Graphics Elevator and Aileron Push-rod wire Three Micro Control Horns All necessary wood parts Carbon fiber wing spar and elevator spars Fully illustrated building instructions ... - Page 3 You will need to Find the following detach the ailerons parts and lay out on and elevator from your work table as both wing halves and shown. This will both elevator halves. ensure you build a right and a left side. Glue the half fuselage to the former as Flip over the elevator...
- Page 4 The new slot should Take two of the wood be widened enough to sticks and glue them allow the 6mm eleva- to the underside of tor to slide in without the fuselage as breaking the Depron. shown. Sand a taper to the tail end pieces to make it fit.
- Page 5 Make sure you glue Locate the 4 elevator the spar while the parts. Glue the to assembly is on a flat halves together and surface. Make sure glue in the carbon your wing stays fiber spar. Work on straight. the elevator control surfaces next.
- Page 6 Glue the flat spar to Bend back the eleva- the front edge of the tor all the way back elevator as shown. and tape the bottom Make sure it is flush side to finish off this with the edge. hinge. Glue the remaining Your completed elevator half.
- Page 7 Continue with one With a sponge type more level of filling sanding block smooth the sides with scrap down the corners to depron. Try to make it make a rounded from one piece on fuselage bottom. each side. Secure with more Thin foam safe CA.
- Page 8 Continue with this Attach the elevator process for all the and make sure it is wings. squared up to the fuselage. Once you are sure it is aligned then glue it with Thin foam safe CA. Apply a few drops and let it seep into the joint.
- Page 9 Be careful not to Cut out a servo hole accidentally sand to fit your servos. Do other parts of the not cut through the plane. wood as you will weaken the fuselage if you do. Just cut away the Depron. Fill in the rest of the Measure the width of fuselage end to make...
- Page 10 Cut down to the At this point your height of the servo should trial fit all your arm as shown. gear and test if all surfaces are moving as they should and check if the battery position is right in order to find the CG.
- Page 11 Finish off the tail end Feel free to leave comments in the guestbook at by cutting off the www.nanoplanes.net. unneeded part as shown. Glue in place the top cover. Tape the pushrod tube to the side of the fuse- lage.