105.1 Tools; 105.2 Installation Considerations; 105.3 Battery Installation Procedure - Philips Bodine ELI-S-600 Installation And Operation Instructions Manual

105.1 Tools

The following tools are required to install the system batteries:
Socket Set, Phillips Screwdriver, Electrical Tape, Digital Volt-Ohm Meter, Safety Glasses with Side Shields
CAUTION:
Always use insulated tools for battery installation.

105.2 Installation Considerations

This section explains how to install the Inverter system's batterys, fuses, and cables. A qualified electrician who is familiar with battery
installations and applicable building and electrical codes should instill the batteries.
MAKE SURE THE DC BREAKER IS IN THE OFF POSITION BEFORE PROCEEDING
The DC fuse (F1) is shipped instilled from the factory and is located in the fuse block holder in the front of the unit.

105.3 Battery Installation Procedure

Battery Voltage: Select which diagram to use from this table:
IMPORTANT:
Be careful to observe correct polarity on the battery terminals. Illustrations are given as a guide only, polarity marking
may vary from battery to battery.
105.3A WIRING DIAGRAM 1 - ELI-S-600
72 volt Battery Connection Diagram
Black Battery Lead
Upper-Tier Batteries Located in the Bottom of the Electronics Cabinet
Lower-Tier Batteries Located in the Bottom of the Battery Cabinet
IMPORTANT:
Use only Philips Emergency Lighting supplied batteries to assure proper operation and maintain system warranty.
DO NOT TURN ON THE DC BREAKER AT THIS TIME AS SIGNIFICANT DAMAGE TO THE SYSTEM MAY OCCUR
(See Section 108 for proper system start-up procedure)
System Model
System DC Voltage
Battery Part Number
Number of Batteries
Wiring Diagram
Red Battery Lead
Intercell
Connectors
Intercell
Connectors
ELI-S-600
72
1000010241
6
3
NOTE: Route the red
battery lead and the
inter-tier connection
lead through the
insulating bushing on
the right hand side of
the electronics module
cabinet.
8