Preparation; Ptional; Attery Ack - Kenwood NEXEDGE NX-200 Instruction Manual

i / r
nStAlling emoving the
1 Match the guides of the
battery pack with the grooves
on the upper rear of the
transceiver, then firmly press
the battery pack in place.
2 Lock the safety catch to
prevent accidentally releasing
the battery pack.
3 To remove the battery pack,
lift the safety catch, press the
release latch, then pull the
battery pack away from the
transceiver.
Note:
◆ For battery pack charging procedures and useage, refer to the
battery charger Instruction Manual.
◆ Before charging a battery pack that is attached to the
transceiver, ensure that the safety catch is firmly closed.
◆ While operating the transceiver using a Li-ion battery pack in
areas with an ambient temperature of –0°C/ +4°F and lower,
operating time may be shortened.
i
nStAlling the
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
2

PREPARATION

(o

ptionAl

(o ) A
ptionAl ntennA
) B p
Attery Ack
1
Optional
antenna
2
3