Setting Up Your Log Splitter - MTD 580 Series Operator's Manual

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
3
Setting Up
Your Log
Splitter
WARNING
Use extreme cau-
tion unpacking this
machine. Some
components are very
heavy and will require
additional people or
mechanical handling
equipment.
NOTE: All references
in this manual to the
left or right side of the
log splitter is from the
operating position only.
Exceptions, if any, will
be specified.
Figure 3-1
Figure 3-
Figure 3-3
www.mymowerparts.com www.mymowerparts.com
WARNING: Use extreme caution
unpacking this machine. Some
components are very heavy and will
require additional people or mechanical
handling equipment.
IMPORTANT: Your log splitter may be shipped with motor
oil in the engine. You MUST check the oil level before
operating. Be careful not to overfill.
NOTE: All references in this manual to the left or right
side of the log splitter is from the operating position only.
Exceptions, if any, will be specified.
NOTE: Engine styles and models vary. The engine found
on your log splitter may not resemble the engine pictured
on illustrations throughout this manual. Refer to the
engine manual packed seperately for all engine informa-
tion and specifications.
Loose Parts In Carton
• Reservoir Tank and Engine-Pump Assembly
• Engine-Pump Assembly Hardware
• Wedge, Beam, and Cylinder Assembly
• Tongue Assembly
• Wheels
• Hitch Assembly
• Beam Support/Latch Bracket
• Log Cradle Brackets and Hardware
• Fenders (If Equipped)
• Tail Light Kit (If Equipped)
• 2 Hub Caps
Assembling the Tongue
Attaching the Beam Support
1. Remove the two hex bolts and lock nuts from the
tongue. See Figure 3-1.
2. Place the beam support/latch bracket on the tongue
and secure with the hex bolts and lock nuts previously
removed. Tighten securely.
Attaching the Jack Stand
The jack stand is shipped in the transport position.
1. Remove the spring clip and clevis pin and pivot
the jack stand towards the ground to the operating
position.
2. Secure the jack stand in position with the clevis pin
and spring clip. See Figure 3-2.
6