Advertisement
pressing the PTT button before you start talking to
5. Press WX/LOCK again. The radio returns to
prevent cutting off your transmission.)
2. When you are finished speaking, release the PTT
button. You can now receive incoming calls. While
receiving, the rx icon displays.
You can only manually cycle through channels when
Transmitting a Call Alert Tone
Key Lock
Your radio is equipped with a call tone that transmits
1. Press and hold WX/LOCK;
when the CALL/MON key is pressed. You can select from
10 call tones.
1. Press MENU/
until call displays on the screen
and the call tone number displays.
2. Press ▲ or ▼ to cycle through the call tones. A
sample of the tone sounds as you move through
them
2. Press and hold WX/LOCK again;
3. The radio returns to its normal state after about 5
seconds.
Backlight
To transmit the call tone, press the CALL/MON key.
Press and hold CH/
The screen stays illuminated for 10 seconds before
Auto Squelch Feature
the backlight turns off.
The radio is equipped with an automatic squelch
system which shuts off weak transmissions and
unwanted noise due to terrain conditions or range
limitations.
CH
Monitor Mode Feature
Your radio allows you to listen for weak signals on the
1
current channel at the press of a key.
2
To turn ON monitor mode:
Press and hold CALL/MON for 2 seconds. On a
3
channel that does not have activity, you will hear only
an open-squelch hissing noise and rx displays.
4
To turn OFF monitor mode:
5
Press the CALL/MON key for 2 seconds again. rx does
not display.
6
Weather Channels
Your radio can access 7 NOAA weather channels and
7
you can select one of these channels to be monitored
while you are listening to GMR transmissions. When
8
weather alerts are broadcast on that channel, the radio
9
tunes to that channel so you can hear them.
10
While you are listening to weather channels, the radio
11
does not receive GMRS communications.
1. To access the weather channels, press WX/LOCK.
The weather channel number and the
icon
display.
2. Press CH/
. The weather channel number
To clean the radio, use a soft cloth dampened with
flashes.
water. Do not use cleaners or solvents because they
3. Press ▲ or ▼ to manually cycle through the
can harm the body of the unit and leak inside, causing
weather channels.
permanent damage. Use a dry, lint-free cloth to clean
the battery contacts. Do not submerge the unit in
4. If there is a weather channel you want to
water. If the unit gets wet, turn it off and remove the
designate as the weather alert channel, press CH/
batteries immediately.
again. The channel numbers stop flashing.
Dry the battery compartment with a soft cloth to
minimize potential water damage. Leave the battery
normal mode and the
icon and alt display,
compartment cover off overnight to ensure complete
indicating there is a weather channel set to alert
drying. Do not use the radio until the unit is completely
mode.
dry.
the channel numbers are flashing
displays. The
Channels
following functions are not affected by Key Lock:
Weather
• Volume adjust
Channels
• Enter monitor mode
• PTT transmission
Operating
Frequency
• Backlight
• Power off
Power
Source
disappears.
to turn on the LCD backlight.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
FREQUENCY CHART
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Freq.[MHz] -
CH
Freq.[MHz] -
Cross Ref.
Cross Ref.
Unauthorized changes or modifications to this
equipment may void compliance with the FCC Rules.
462.5625 - FRS &
12
467.6625 - FRS 12
Any change or modification must be approved in
GMRS 1
writing by Uniden. Changes or modifications not
462.5875 - FRS &
13
467.6875 - FRS 13
approved by Uniden could void the user's authority to
GMRS 2
operate the equipment.
462.6125 - FRS &
14
467.7125 - FRS 14
To be safe and sure:
GMRS 3
• Never open your radio's case.
462.6375 - FRS &
15
462.5500 - GMRS 11
GMRS 4
• Never change or replace anything in your radio
except the batteries.
462.6625 - FRS &
16
462.5750 - GMRS 8
GMRS 5
Your radio might cause TV or radio interference even
when it is operating properly. To determine whether
462.6875- FRS &
17
462.6000 - GMRS 12
your radio is causing the interference, turn it off. If the
GMRS 6
interference goes away, your radio is causing it. Try to
462.7125 - FRS &
18
462.6250 - GMRS 9
eliminate the interference by moving your radio away
GMRS 7
from the receiver. If you cannot eliminate the
467.5625 - FRS 8
19
462.6500 - GMRS 13
interference, the FCC requires that you stop using the
radio.
467.5875 - FRS 9
20
462.6750 - GMRS 10
467.6125 - FRS 10
21
462.7000 - GMRS 14
Hazardous Environments: Do not operate the radio in
hazardous environments. Explosion or fire may result.
467.6375 - FRS 11
22
462.7250 - GMRS 15
Do not operate the radio near unshielded electrical
blasting caps.
CARE AND SAFETY
Under certain conditions, radios can interfere with
blasting operations and may cause an explosion. Turn
your radio OFF to prevent accidental transmission
when in a blasting area or in areas posted: "Turn off
two-way radio." Construction crews often use remote
control RF devices to set off explosives.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
SPECIFICATIONS
interference that may cause undesired operation.
Unauthorized changes or modifications to this equipment may
15 GMRS/7 FRS
void compliance with I.C. Rules. Any change or modification must
7
be approved in writing by Uniden. Changes or modifications not
approved by Uniden could void the user's authority to operate the
equipment.
UHF 462.5500 - 467.7125 MHz
L'appareil est conforme aux normes d'Industrie Canada. Son
fonctionnement est soumis aux deux conditions suivantes : (1)
3 AA NiMH Batteries per radio.
Ce dispositif ne doit pas causer d'interférences et (2), il doit
pouvoir accepter les interférences, incluant celles pouvant nuire à
son fonctionnement normal.
FCC INFORMATION
Tous les changements apportés à cet appareil, s'ils ne sont pas
expressément approuvés par Uniden ou toute utilisation de celui-
ci d'une autre manière que celle décrite dans ce guide peut
annuler votre autorisation de le faire fonctionner.
FCC RF EXPOSURE INFORMATION
WARNING! Read this information before using the radio.
In August 1996 the Federal Communications Commission (FCC)
of the United States with its action in Report and Order FCC
96-326 adopted an updated safety standard for human exposure
to radio frequency electromagnetic energy emitted by FCC
regulated transmitters. Those guidelines are consistent with the
safety standard previously set by both U.S. and international
standards bodies. The design of the radio complies with the FCC
guidelines and these international standards. Never allow children
to operate the radio without adult supervision and the knowledge
of the following guidelines.
WARNING! It is up to the user to properly operate this radio
transmitter to insure safe operation. Please adhere to the
following: Use only the supplied or an approved antenna.
Unauthorized antennas, modifications, or attachments could
impair call quality, damage the radio, or result in violation of FCC
regulations.
Do not use the radio with a damaged antenna. If a damaged
antenna comes into contact with the skin, a minor burn may
result. Please contact your local dealer for a replacement
antenna.
Body-Worn Operation
This device was tested for typical body-worn operations using the
supplied belt-clip. To maintain compliance with FCC RF exposure
requirements, Body-worn operations are restricted to the supplied
belt-clip. For hand-held operation, the radio should be held 1 inch
from the user's face. The use of accessories that do not satisfy
these requirements may not comply with FCC RF exposure
requirements and should be avoided. For more information about
RF exposure, please visit the FCC web site at: www.fcc.gov.
© 2015 Uniden America Corporation
All rights reserved
For body worn operation, this device has been tested and meets
IC INFORMATION
the Industry Canada RF exposure guidelines when used with
Uniden accessories supplied or designated for this product. Use
of other accessories may not ensure compliance with Industry
Canada RF exposure guidelines.
Fonctionnement de l'appareil, lorsque porté sur le corps. Cet
appareil a été testé et s'est avéré conforme aux normes
d'Industrie Canada et approuvé pour le port sur le corps à l'aide
des accessoires Uniden inclus et conçus pour cet appareil.
L'utilisation d'accessoires ne respectant pas les exigences
d'exposition RF d'Industrie Canada doit être évitée.
ONE YEAR LIMITED WARRANTY
Important: SAVE YOUR RECEIPT! Evidence of original purchase
is required for warranty service.
WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail
owner, this Uniden Product to be free from defects in materials and craftsmanship
with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate and be
of no further effect 12 months after the date of original retail sale. The warranty is
invalid if the Product is: (A) damaged or not maintained as reasonable or
necessary, (B) modified, altered, or used as part of any conversion kits, sub-
assemblies, or any configurations not sold by Uniden, (C) improperly installed, (D)
serviced or repaired by someone other than an authorized Uniden service center for
a defect or malfunction covered by this warranty, (E) used in any conjunction with
equipment or parts or as part of any system not manufactured by Uniden, or (F)
installed or programmed by anyone other than as detailed by the owner's manual for
this product.
STATEMENT OF REMEDY: In the event that the product does not conform to this
warranty at any time while this warranty is in effect, warrantor will either, at its
option, repair or replace the defective unit and return it to you without charge for
parts, service, or any other cost (except shipping and handling) incurred by
warrantor or its representatives in connection with the performance of this warranty.
Warrantor, at its option, may replace the unit with a new or refurbished unit.
THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE
WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND
EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER,
WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW,
INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.THIS
WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT
OVERPAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states
do not allow this exclusion or limitation of incidental or consequential damages so
the above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state. This warranty is void outside the
United States of America and Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If, after
following the instructions in the owner's manual you are certain that the Product is
defective, pack the Product carefully (preferably in its original packaging). The
Product should include all parts and accessories originally packaged with the
Product. Include evidence of original purchase and a note describing the defect that
has caused you to return it.The Product should be shipped freight prepaid, by
traceable means, to warrantor:
Uniden America Corporation
C/O Saddle Creek
743 Henrietta Creek Road, Suite 100
Roanoke, TX 76262
(800) 297-1023, 8 a.m. to 4:30 p.m., Central, Monday through
Friday
Issue 2, September 2015
Printed in China
Advertisement
