Advertisement
6. Secure drive clutch
lever to weld bolt with rub-
ber washer (T), flat washer (U) and hex lock nut.,(V).
See figure 13. Tighten
hex nut.
7. Place the drive clutch
lever in the neutral
(N)
position.
Adjust
the
cables
at the
cable
bracket
so that
the
cables
are tight,
then
tighten
the
hex
nuts
against
the
cable
bracket.
FIGURE 13.
IMPORTANT
Service engine with oil and gasoline
before checking
the drive clutch
adjustment.
Refer to the separate
engine manual packed with your
tiller.
8. Check the adjustment
of the drive clutch as
follows. Place the unit against a solid object
(wall, fence, etc.). With the tine clutch lever
released and the drive clutch
lever in the
neutral position,
carefully start the engine. If
the unit shows any signs of motion with the
drive clutch lever in neutral, shut the engine
off immediately and readjust the hex nuts at
the cable bracket. Recheck the adjustment as
necessary .
9. Secure the cables to the handles as with cable
ties (L). Cut off excess ends of cable ties.
CONTROLS-Location
and Use
Tine Clutch
Lever
The tine clutch
lever is located
on the left handle.
See figure
14.
Squeeze
the
lever
down
to engage
the tines.
Release the lever to disengage
the tines.
Throttle
Control
The throttle control lever is located on the right
hand side of handle panel and controls the engine
speed. See figure 14.
1. Start-Push
throttle
control
lever forward
(down) to start position.
2. Stop-Pull
lever back (upward) to stop the
engine.
Tine
Clutch
Lever
Drive
Clutch
Lever
~~
O\
Drive Clutch
Lever
The drive clutch
lever is located
on the left hand
side of handle panel. See figure
14.
The drive clutch
lever
may be placed
in one of
three positions.
1. Forward
(F)-Move
the drive clutch
lever to
the left and all the way forward
to engage the
drive mechanism
to the wheels.
2. Neutral (N)-Move
lever to the detent marked
"N".
Be certain
lever
is in neutral
position
when starting
the engine.
3. Reverse (R)-Raise
up on the handles
to lift
the tines out of the ground
and pull the drive
clutch
lever back (upward)
slowly
to obtain
reverse.
Always
use caution
when using
the
reverse. When using reverse,
if gear shift lever
is released
it will snap back into neutral (N).
,
"0
"
\
'f
\'\O~
FIGURE 14.
8
Throttle
Control
Advertisement
