Table of Contents
Advertisement
Getting started...
-
Please install heat spreader as described in the prior section.
-
Insert a boot device (SD card, mSATA SSD, USB stick, or PXE through LAN).
-
Connect serial port to a PC through null modem cable (RXD / TXD crossed over). Set terminal
emulator to 115200 8N1.
-
Connect Ethernet as needed.
-
Connect a 12V DC power supply to the DC jack. Power supply should be able to supply at least
18W for some margin. To avoid arcing, please plug in the DC jack first, then plug the adapter
into mains.
The board should now power on. All three LEDs will light during BIOS POST, then the system will
try to boot. You should see BIOS messages on the serial console. Press F12 for boot device
selection:
Build date: Apr
System memory size: 2017 MB
Press F12 for boot menu.
Select boot device:
1. USB MSC Drive
2. iPXE (PCI 00:00.0)
3. Payload [setup]
4. Payload [memtest]
Setup options
To set up the boot sequence and other options, press F12 for boot device selection, then select
Payload [setup].
==============================================
Type lower case letter to move device to top
==============================================
boot devices
a SD Card
b USB 1
c USB 2
d mSATA
e SATA 2
f SATA 3
g NETWORK / PXE
==============================================
Type upper case letter to invoke action
==============================================
R Restore boot order defaults
N Network/PXE boot - Currently Enabled
S Serial console - Currently Enabled
E Exit setup with save
X Exit setup without save
The lower case letters will change the boot sequence, pull the selected device to the top of the list.
R
toggles serial console enable. Push the switch S1 during startup to get into setup when
the serial console is disabled.
apu system board
1 2014
8.07
6
7/31/2014
Hide quick links:
Advertisement
Table of Contents
