Waterline essentials ESSGH60E Users Manual & Installation Handbook page 14

Fit the hob into the cutout &
secure to worktop
Place the hob into the cutout and
secure in place using the four brackets
and screws provided.
The brackets should be orientated to
suit the worktop thickness as shown,
then inserted into the four slots (two on
the front edge and two on the rear) and
screwed into the underside of the work-
top using the woodscrews provided
The screws should be tightened just suf-
ficiently to secure the hob and pull the
top pressing flush with the worktop.
If the base of the hob is accessible after
installation then a partition must be fitted
20mm below the base to prevent access.
Installation advice - cabinetry
Dealing with sides, cross-rails
and back-panels in cabinetry Depending
on the cabinets, the worktop thickness
and the hob positioning, it is possible for
the hob base, the clamp brackets and/or
the gas connection to interfere with parts
of the cabinet.
These can be dealt with as
follows:
Cabinet sides
If the hob is to be installed across the
top of two cabinet housing units, then
the base of the hob may interfere with
the sides of these units. It will be neces-
sary
to cut away the top of the unit
sides locally to clear the hob, clamp
brackets and/or gas connection.
Cross-Rails
1. Interference with hob base.
If there are any cross-rails which
obstruct the hob base by running
across the worktop cutout, they
can simply be removed or locally
cutaway to allow the hob to be in-
stalled, depending on the particular
installation. Any modifications must
ensure that the strength of the cabi-
net is maintained.
2. Interference with clamp brackets.
If there are any cross-rails which
prevent the clamps from being
positioned on the front or rear
edges of the hob, then they can be
removed or locally cut-away around
the brackets to allow the brackets to
be installed.
Any modifications must ensure that the
strength of the cabinet is maintained.
Back-panel
1. Interference with clamp brackets.
If the cabinet has a back-panel
which prevents the clamps from
being positioned on the rear edge of
the hob, then this panel can be com-