Advertisement
Filter assembly
For best performance and results, the filter assembly must be
cleaned. The filter efficiently removes food particles from the
wash water, allowing it to be recirculated during the cycle. For
this reason, it is a good idea to remove the larger food particles
trapped in the filter after each wash cycle by rinsing the
semicircular filter and cup under running water. To remove the
filter assembly, pull on the cup handle in the upward direction.
The entire filter assembly should be cleaned once a week.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble
the filter parts as shown in the figures left and reinsert the entire assembly in the
dishwasher, positioning in its seat and pressing downward. The dishwasher must
never be used without the filters. Improper replacement of the filter may reduce the
performance level of the appliance and damage dishes and utensils.
Never run the dishwasher without the filters in place.
Also, never use abrasive cleaners or scouring pads on the
-10-
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should be filled as follows:
1. Remove the lower basket and then unscrew and remove
the cap from the salt container.
2. If you are filling the container for the first time ,fill 2/3 of
its volume with water(around 500ml).
4. Carefully screw the cap back on.
5. Usually, the salt warning light will be off in 2-6 days after
the salt container be filled with salt.
Contact your local w ater board for inform ation on the hardness of your w ater supply.
-7-
Advertisement
