STEP 1
DBS/Phone Hookup
NOTE:
The PowerCenter is intended for hookup of a single phone line only. A second line will NOT be connected through
the phone line surge protector. You can use the HTS 5000
use, the "PHONE IN USE – OUT1" LED will light up and the OUT 2 outlet will be disengaged. If the OUT 2 outlet
is in use, the "PHONE IN USE – OUT2" LED will light up and the OUT 1 outlet will be disengaged. This telephone
privacy circuit prevents eavesdropping.
FOR PAY-PER-VIEW DEVICES (SUCH AS DBS)
A) Connect one end of a phone cable into a telephone wall jack. Plug the other end into the HTS 5000
jack (figure 1a).
B) Connect a second phone cable from either the "OUT 1" or "OUT 2" jacks to the Pay-Per-View input on your
DBS receiver (figures 1b and 1c).
FOR STANDARD TELEPHONE LINE PROTECTION (NOT A PAY-PER-VIEW DEVICE)
A) Connect a phone cable from a telephone wall jack to the HTS 5000
cable from either the "OUT 1" or "OUT 2" jacks to the telephone (figures 1b and 1c).
Figure 1a
From telephone
wall jack
HOOKUP GUIDE
as a phone splitter, however. If the OUT 1 outlet is in
MKII
MKII
IN
OUT 1
PHONE
OUT 2
Figure 1
"IN"
MKII
"IN" jack. Connect a second phone
Figure 1b
To DBS receiver or telephone
Figure 1c
To DBS receiver or telephone
6