Battery Installation & Charging - AT&T E597-1 User Manual

Battery installation & charging
After battery installation, place the handset in the charger and allow it
to charge for 16 hours before use. You can keep the battery charged by
returning the handset to the charger after each use. When the battery is
fully depleted, a recharge takes about 12 hours. The average talk time on a
fully charged battery is about eight hours depending on environmental condi-
tions, standby time is approximately four days.
Press in and downward on
the tab to open the battery
compartment cover.
Plug power adapter into
the jack on the underside
of charger as shown, then
plug into electrical outlet.
Caution: Use only supplied rechargeable battery or replacement battery pack (Part Number
80-5848-00-00).
NOTE: Use only the power cord and adapter supplied with this product. If you need a replace-
ment, call 1-800-222-3111. In Canada, call 1-866-288-4268. Be sure to use an electrical outlet
not controlled by a wall switch.
Plug the battery
pack connector
into handset.
Place handset in base or
charger to charge for 16
hours before first use.
4
Place the battery
pack and wires in
the compartment.
Low battery indicator
Return handset to base or
charger to recharge when this
symbol flashes. (Handset will
beep when battery is low.)
Slide battery compartment
cover up until it clicks closed.
LOW BATTERY