91-5661-20-00.E250.R0.qxd 02/13/1950 You must charge batteries and register the hand- set before use. For customer service or product information, visit our web site at w w w.telephones.att.com 1-800-222-3111. or call Before you begin...1 Parts checklist...1 Battery installation & charging...2 Registering the handset...3 Belt clip &...
91-5661-20-00.E250.R0.qxd 02/13/1950 Before you begin This cordless telephone operates with the maximum power allowed by the Federal Communications Commission (FCC). Even so, this handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office.
91-5661-20-00.E250.R0.qxd 02/13/1950 Battery installation & charging Install batteries as shown, then place the handset in the charger for at least 8 hours before use. You can keep batteries charged by returning the handset to the charger after each use. When battery power is fully depleted, a full recharge takes about 6 hours. Press coin into slot on base of handset to release latch, then...
91-5661-20-00.E250.R0.qxd 02/13/1950 Registering the handset Enter base ID, then press OK. ENTER BASE ID 123456789012345 < HANDSET 2 REDIAL MENU 19:21 Page 3 Before using your new handset, you must register it with the base. During registration, you must enter the 15-digit ID number of the telephone base.
91-5661-20-00.E250.R0.qxd 02/13/1950 Belt clip & optional headset Install belt clip as shown below if desired. For hands-free telephone conversations, you can use any industry standard 2.5 mm headset (purchased separately). For best results use an AT&T 2.5 mm headset. 19:21 Page 4 Snap belt clip into notches on side of handset.
91-5661-20-00.E250.R0.qxd 02/13/1950 Quick reference guide For complete instructions, please refer to the manual provided with your telephone. Softkeys Press a softkey to select a menu item displayed just above the key. Phone/Flash Press to begin a call, then dial a number. During a call, press to receive an incoming call, if Call Waiting is activated.