32JW-73E SERVICE MANUAL SE0032JW73E01 Issued: 20 Dec. 2002 GA-20 CHASSIS / SECAM SYSTEM COLOUR TELEVISION B/G, I L/L’, B/G, D/K MODEL 32JW-73E ES/SE In the interests of user safety (required by safety regulations in some countries) the set should restored to its original condition and only parts identical to those specified should be used.
Page 2
32JW-73E SERVICE MANUAL UPDATE LOG SHEET Technical Report No. Application Cause / Solution Part No. Page No. Data /Serial No. Technical Bulletin No. Use this page to keep any special servicing information as Technical Report (Bulletin), Technical Information, etc. If only part number changes are required, just change part number directly the part number in the Parts Listing Section.
32JW-73E IMPORTANT SERVICING NOTES Only qualified service personnel are allowed to carry out maintenance and repair of this receiver. Servicing of High Voltage System and CRT It is important that the static charge is removed from the high voltage system when carrying out work on the receiver.
32JW-73E CONTROLS & TERMINALS ■ FRONT TV Main power button Power indicator Remote control sensor Volume DOWN button Volume UP button Channel DOWN button 3 4 5 6 7 Channel UP button Door HOW TO OPEN THE DOOR Press the top of the door, opening it slightly hook your finger inside and pull open.
32JW-73E • • • • • Use the channel up and down buttons to move between the options. • • • • • Use the volume control buttons to change the data. • • • • • To store the data, use the stand-by button on the remote control.
Page 8
32JW-73E Note that the receiver should be set to FULL MODE before carrying out any geometry adjustments. This can be achieved by pressing the widescreen mode button on the remote control until FULL MODE appears on the OSD. This can only be done out of the Service Mode.
Page 9
32JW-73E Corner Amplitude Adjust the Corner Amplitude so that the picture is centred. The effect of this adjustment is shown in figure 6. Note: This adjustment affects to upper and lower sides. • When the volume up button is pressed, side pincushion changes from pincushion to barrel shape.
Page 10
32JW-73E S Correction Adjust the S Correction so that the picture symmetrical between the top, centre and bottom. The effect of this adjustment is shown in figure 12. • When the volume up button is pressed, the top and bottom scanning increases and the centre scanning decreases.
Page 11
5. If another NVM value has to be changed, use the channel down button to select the page or position and repeat as necessary. Note: DO NOT change any NVM data, unless you have been advised to do so by a Sharp representative. If data is incorrectly changed, serious damage may occur to the receiver.
32JW-73E DVCO Adjustment (PAL) Carry out the DVCO Adjustment (PAL) as shown below: 1. Receive a Philips pattern signal. 2. While in the DVCO ADJUSTMENT (PAL) menu, press the stand-by button. 3. The adjustment will be carried out automatically and stored.
32JW-73E ICs ADDITIONAL INFORMATION TDA9886 (IC201) QUICK REFERENCE DATA SYMBOL PARAMETER CONDITIONS MIN. TYP. MAX. UNIT supply voltage notes 1 and 2 supply current Video part −1 dB video at output − µV VIF input voltage sensitivity i(VIF)(rms) (RMS value) −...
32JW-73E TDA9886 (IC201) SYMBOL PARAMETER CONDITIONS MIN. TYP. MAX. UNIT −3 dB AF bandwidth − without de-emphasis; AF(−3dB) dependent on FM-PLL filter − weighted signal-to-noise ratio of FM: 27 kHz FM deviation; W(AF) 50 µs de-emphasis; audio signal vision carrier unmodulated −...
32JW-73E TDA7480 (IC1301,IC1302) TDA7480 ABSOLUTE MAXIMUM RATINGS Symbol Parameter Value Unit ±20 DC Supply Voltage Storage and Junction Temperature –40 to 150 °C Maximum Voltage Across VFREQ (Pin 9) FREQ Operating Temperature Range -20 to 70 °C ±1.8 Maximum ESD on Pins PIN CONNECTION (Top view) Rth with "on board"...
32JW-73E TDA7480 (IC1301,IC1302) = ±14V; R ELECTRICAL CHARACTERISTICS (Refer to the test circuit, V = 8Ω; R = 50Ω; = 12KΩ; Demod.. filter L = 60µH, C = 470nF; f = 1KHz; T = 25°C unless otherwise specified.) Symbol Parameter Test Condition Min.
32JW-73E MSP3410G (IC301) 4.6.1. Absolute Maximum Ratings Symbol Parameter Pin Name Min. Max. Unit − ° C Ambient Operating Temperature − − 40 ° C Storage Temperature − 0.3 First Supply Voltage AHVSUP SUP1 − 0.3 Second Supply Voltage DVSUP SUP2 −...
32JW-73E TEA1507 (IC701) Block Diagram SUPPLY START-UP V CC DRAIN MANAGEMENT CURRENT SOURCE clamp internal UVLO start n.c. VALLEY supply M-level VOLTAGE CONTROLLED LOGIC OSCILLATOR 100 mV OVER- FREQUENCY VOLTAGE CONTROL PROTECTION OVER- LOGIC DRIVER DRIVER TEMPERATURE PROTECTION I ss −1...
32JW-73E TEA1507 (IC701) CHARACTERISTICS = 25 °C; V = 15 V; all voltages are measured with respect to ground (pin 2); currents are positive when flowing into the IC; unless otherwise specified. SYMBOL PARAMETER CONDITIONS MIN. TYP. MAX. UNIT Start-up current source (pin 8) supply current drawn from drain pin = 0 V;...
32JW-73E TEA1507 (IC701) SYMBOL PARAMETER CONDITIONS MIN. TYP. MAX. UNIT Burst mode standby (pin 3) burst mode standby active threshold at I = 6 mA th(burst)(on) burst voltage − − burst mode standby active current th(burst)(on) − − burst mode standby inactive current th(burst)(off) µs...
32JW-73E DESCRIPTION OF SCHEMATIC DIAGRAMS NOTE: SAFETY NOTE: 1. The unit of resistance « ohm »is omitted (K=1000 1. DISCONNECT THE AC PLUG FROM THE AC ohms. M= Megaohm). OUTLET BEFORE REPLACING PARTS. 2. All resistors are 1/8 watt. unless otherwise noted.
32JW-73E PARTS LISTING 5() 1R 3$576 '(6&5,37,21 61 &2'( (; &2'( 4 966&* 757 6&$7 .25($ 6 $$ REPLACEMENT PARTS 4 966&.4 757 6& 52+0 6 $$ Replacement parts which have special safety characteristics are identified in 4 966$.4...
32JW-73E SOURCE OF DOCUMENTATION 1. TDA 9886, Philips Data Sheet: TDA9885; TDA9886. I C-bus controlled single/multistandard alignment-fee IF-PLL. Product specification. 2002 Mar 05. http://www.semiconductors.philips.com/acrobat/datasheets/TDA9885_TDA9886_1.pdf 2. TDA 7480, ST Microelectronics Data Sheet: TDA7480. 10W Mono Class D Amplifier. September 1998 http://us.st.com/stonline/books/pdf/docs/4839.pdf 3.
32JW-73E PACKING OF THE SET & ACCESSORIES Pack-ad SPAKX4079BMZZ Wrapper SPAKP2014BMZZ FRONT SPAKC5497BMZZ Carton Box Batteries UBATU0013TAZZ Remote Control RRMCG1073BMSA Operation Manual Set R/C Battery Cover GCOVHA010WJSA FRONT Carton Box...