A
BODY ALIGNMENT CHECKING BENCH
ALIGNMENT CHECKING
o
5
For checking the steering box and the
relay crank attachments, use the extension
gauge, special tool P.N. A.8.0056, and,
acting
from
inside
the
engine
com·
partment, proceed as follows:
•
Hold the extension gauge in such a
way that the wing nut
A
is pointing
upward and make sure that the end
flanges bearing the markings Sand D
are positioned respectively at the left
and at the right skirt.
•
Slacken the wingnut
A
and extend the
gauge so that the dowels on the end
flanges can be inserted in the holes in
the skirts.
•
Check that the reference marks on the
two gauge tubes are aligned perfectly
or within a maximum
tolerance
of
!
0.5 mm.
0)
....__ ·_--1fA
13
DIAGRAM OF DIMENSIONS OF MAIN UNIT ATTACHMENTS