operating modes
There are distinct operating modes that are supported by this unit. To select,
use the "MENU" button to enter the menu. The "UP" and "DOWN" buttons steps
through specific settings for each operating mode and the "ENTER" buttons
chooses from the values available.
MENU ENTER
show programs
With the LED display is reading "SHOW MODE", Choose between 2
built-in programmes. Use the "UP" and "DOWN" buttons step between "SHOW
MODE 1" & "SHOW MODE2".
With the LED display is reading "SLAVE MODE" means the fixture is in slave
mode and will mimic the 'Master' fixture, when connected through a DMX
cable.
manual control
Within this mode, you can manually adjust the fixture. When the LED display is
reading any of the following, Use the "UP" and "DOWN" buttons steps through
specific values for each section between '000 - 255'.
led display shows
000 - 127
PAN
000 - 127
TILT
RED
000 - 255
GREEN
000 - 255
BLUE
000 - 255
WHITE
000 - 255
Within this mode, you can reset all the manual control features back to "000"
and take this fixture back to its original dormant state.
Within this mode, you can adjust the LED display brightness between "00" and
"10" or if you wish the back light to be ON or OFF.
© Lanta Lighting™ 2006-2015. Terms Apply. All trademarks are the property of their respective owners. E&OE. All specifications and details are correct at time of print.
Neptune Tumbler
neptune
tumbler
UP
DOWN
show
mode
slaVe mode
slave
mode
MANUAL
CONTROL
Value
effect
360° ADJUSTMENT
128-191
PAN CLOCKWISE
192-255
PAN ANTI - CLOCKWISE
360° ADJUSTMENT
128-191
TILT CLOCKWISE
192-255
TILT ANTI - CLOCKWISE
RED
GREEN
BLUE
WHITE
reset
reset
led displaY
back
light
Owner Handbook
With the LED display is reading either "PAN" or TILT" Inverse, Use the "UP" and
"DOWN" buttons to select [YES] or [NO] to invert that rotation.
Within this mode, you can what version of CPU this fixtrue is running.
Here you can restore this fixture to factory settings.
With the LED display is reading "SOUND STATE", you can turn the sound
activated mode ON or OFF. Also when the display reads "Sose" you can
adjust the sensitivity between "000" and "255".
With the LED display is reading "DMX ADDRESS" the required address can be
chosen. Use the "UP" and "DOWN" buttons step between "001" & "512" for the
DMX address you require.
With the LED display is reading "CHANNEL MODE" the DMX channels can be
chosen. Use the "UP" and "DOWN" buttons step between the different channels
available.
This mode will run the fixture through a series of LED tests, rotations which can
highlight if any of the LEDs or rotations are not functioning properly.
4
™
pan & tilt inVerse
pan
tilt
inverse
inverse
cpu Version
version
FactorY settings
factory
sets
sound state
sound
state
dmx address
DMX
ADDRESS
dmx channels
CHANNEL
mode
led display shows
dmx control mode
9CH
9 CHANNEL
19CH
19 CHANNEL
auto test
AUTO
TEST
Revision 1