GE Cafe series Owner's Manual And Installation Instructions page 41

Problem
PRECISE FILL will not fill container
Photos not found
Freezer cooling, fresh food not cooling Normal, when refrigerator first plugged
Ice dispenser opens after closing
freezer drawer
Hot water does not work
Hot water continues to dispense for a
short time after releasing the knob
Difficult to open the Icebox door
Fresh food door not closing fully
Low brewing flow rate
Low brewing flow rate / water drips
from inner door
Brewer stuck in the door bracket
Brewer is not detected by the screen
menu or hot water leaking from top of
the brewer
Coffee dispensed with splash or
bubble bursting
Beverage quality not as expected
Liquid drips from the brewer after
brewer cycle is completed and the
brewer is removed from the bracket
Possible Causes
Normal, PRECISE FILL requires use of
dispenser paddle
Photos not in root directory of USB
Photos not in JPEG format
Camera/PC used with USB cord
in or after extended power outage
Normal
Operation disabled
Low water pressure
Water supply line turned off or not
connected
Water filter clogged or filter/bypass plug
not installed
Water filter is partially clogged or low
water pressure (<40 psi)
Icebox door gasket might stick to main
door if it remains closed for a long
duration
Fresh food door gasket may have
unseated and interfering with
articulating mullion operation
There may have been a dent at the
bottom of K-Cup causing the pin to
pierce the filter allowing coffee grounds
clogging the bottom pin
Top needle of the brewer clogged
Dispenser is in hot water dispense mode
instead of brew mode while the brew
module is installed
Incorrect assembly of brewer in the
bracket
Blocked vent hole in the brewer
You may be using non-standard or out
dated K-Cups
It is possible for liquids to be retained by
the brewer and drip when it is removed
41
GEAppliances.com
What to Do
For a specific amount of water, select
PRECISE FILL to dispense water
Make sure the photos are in the root
directory in your USB
Photos must be in JPEG format
Must use a USB drive
Wait 24 hours for temperature in both
compartments to reach selected
temperatures.
The ice dispenser door may open after
closing freezer door to allow access
Make sure "Hot Water Disabled" is not
selected
Make sure water line is not kinked
See Installing the Water Line
Replace filter cartridge or remove filter
and install bypass plug
Replace filter cartridge or remove filter
and install bypass plug or increase
water pressure
Disengage the door latch, wait for 3
minutes then open the Icebox door
Reseat the gasket all the way in the
groove
Avoid using damaged/dented K-cups,
and clean the lower needle before next
brew
Unclog the top needle holes using
a paper clip and rinse brewer. Rinse
brewer after every use.
Cancel hot water dispense mode so hot
water tube will retract from the brew
module
Make sure the Keurig Logo is in the
front. Push brewer all the way in the
brackets
Make sure the vent hole at the bottom
of the brewer is clear from food or any
other contamination
Recommend using official Keurig K-cups
that are not past expiration and have
not been damaged
Use a cloth or container to capture the
drips when brewer is removed