Advertisement
Advertisement
Table of Contents
Related Manuals for Show Atelier DIALighting IW7-10
Summary of Contents for Show Atelier DIALighting IW7-10
- Page 1 DIALighting IW7-10 USER MANUAL PLEASE KEEP THIS FOR FUTURE USE...
-
Page 2: Maintenance And Cleaning
1. Unpacking 9. Maintenance and Cleaning Thank you for choosing our products . For your own safety, please read this manual The following points have to be considered during the inspection: before installing the device. This manual covers the important information on installation 1. -
Page 3: Safety Instructions
2. Safety Instructions 19 ch ann el s mo d e Channel Function Description Value 0-255 0~540 degree This device has left the factory in perfect condition. In order to maintain this condition Pan fine adjustment 0-255 16bit and to ensure a safe operation, it is absolutely necessary for the user to follow the Tilt 0-255 0~270 degree... - Page 4 8. DMX Channels details 3. Operation Instructions 12 channels mode -The moving head is for beam light and effect use. -Don’t turn on the fixture if it’s been through severe temperature difference like after Channel Function DMX Value Description transportation because it might damage the light due to the environment changes. 0-255 0~540 degree So make sure to operate the fixture until it is in normal temperature.
-
Page 5: Menu Panel
4. Specifications : Control Panel Menu Instruction Voltage: AC90-240V 50-60Hz Power: 90W Menu Panel Function Led source: 7pcs high brightness 10W CREE white LEDs Set the DMX address Beam angle: 5-40° Strobe: 1-25 Hz To choose the channel mode Dimmer: 0-100% linear dimmer with 16 bit without strobe Pan auto Run Pan: 540°... -
Page 6: Dmx-512 Control Connections
Mounting points: Overhead mounting requires extensive experience, including amongst 6. DMX-512 control connections others calculating working load limits, a fine knowledge of the installation material being used, and periodic safety inspection of all installation material and the fixture. If you lack Connect the provided XLR cable to the female 3-pin XLR output of your controller and these qualifications, do not attempt the installation yourself.
Need help?
Do you have a question about the DIALighting IW7-10 and is the answer not in the manual?
Questions and answers