Hand-Held Series Generators • Familiarization & Troubleshooting Guide
Disassembly • Section 2
•• Step 3:
• Remove the heat shield mounting screws (Figure 18A).
•• Step 4:
• Remove the rear bearing carrier mount bolts
(Figure 18B).
Figure 18 — Hardware (Heat Shield / Stator Housing)
A
B
•• Step 5:
• Remove the three through-bolts (Figure 19).
Figure 19 — Remove Stator Through-Bolts
•• Step 6:
• Remove the rear bearing carrier and the stator
together (Figure 20).
Figure 20 — Remove Stator Housing & Stator
19
2