Selecting An Input Signal Or Test Pattern; Input Signal; Test Pattern; Adjusting The Lens - Digital Projection lightning series User Manual

Digital Projection
Lightning Series

Selecting an input signal or test pattern

Input signal

•
Connect an image source to the projector. The signal should be automatically detected by the
projector, and should be displayed within two or three seconds.
If more than one signal is connected, then select the image you want to display:
•
Press one of the Input buttons ,
•
Open the On-screen display (OSD) by pressing
•
Select an input signal from the Input Selection

Test pattern

If you have no image source connected to the projector, then you can display a test pattern instead:
•
Open the OSD by pressing .
•
Select

Test Pattern

from the Input Selection
•
Select a pattern from the
Test Pattern
•
Close the OSD by pressing

Adjusting the lens

•
The lens can be adjusted using the

Zoom

•
Press followed by and

Focus

•
Press followed by and

Shift

•
Press followed by ,
.
Rev C May 2013
to or (dual pipe) on the remote control, or
.
menu, using the
menu, using the
menu, using the and
again.
menu, or:
Lens
to adjust the size of the image on the screen. When the adjustment is finished, press
to adjust the focus. When the adjustment is finished, press
, and to adjust the position of the image on the screen. When the adjustment is finished, press
OPERATING THE PROJECTOR
and buttons.
and buttons.
buttons.
.
Installation and Quick-Start Guide
Notes
When any of the three Lens
adjustment keys is pressed, the blue
Transmit indicator on the remote
control will light for 10 seconds:
- after 10 seconds, if no adjustment
has been made, the indicator will
go out and the Lens adjustment key
must be pressed again to resume
adjustment.
- to end the adjustment before 10
seconds has elapsed, press the
key.
- all other adjustments will be locked
out until the Lens adjustment is
ended.
For full details of how to use the
controls and the menu system, see
the Operating Guide.
.
13