Led Speaker Status Indicator; Connecting A Previously Paired Bluetooth Audio Device; Adjusting The Speaker Volume; Pairing Speaker With A Bluetooth Audio Device - DeWalt DCR006 Instruction Manual

LED SPEAKER STATUS INDICATOR

LED indicator
Steady blinking (half
second interval)
Rapid Blinking
Solid light
No light
FIG. 7
C
E
PAIRING SPEAKER WITH A BLUETOOTH
(FIG. 6, 7)
1. Place the speaker and the Bluetooth
(1 m) of each other.
Page dimensions: 8.5 x 5.5 inches
Status/Mode
Speaker is unpaired or in connecting
mode.
Speaker is in pairing mode and
discoverable by your device.
Speaker is connected with a device.
Speaker has timed out and/or is off.
A
D
E
B
®
AUDIO DEVICE
® audio source within 3.3'
2. Turn speaker on by pressing the power button (A). The LED (B)
will light solid for 4 seconds to indicate the apparatus powered on
successfully and then go into a half second interval blink pattern.
®
3. Press the Bluetooth pairing button (C). The LED indicator light
blinks rapidly indicating the speaker is in pairing mode and is
discoverable by your Bluetooth
4. Confirm pairing on your device. (Please consult your device's
instruction manual for specific pairing instructions.)
NOTE: If pairing is not confimed within 2 minutes, the LED will
stop flashing and the speaker will return to half second interval
blink pattern.
5. Once pairing is successful the LED indicator (B) will turn solid
and the speaker will emit a short tone. The speaker will now play
music from your device.
CONNECTING A PREVIOUSLY PAIRED BLUETOOTH
DEVICE (FIG. 1, 7)
®
If a Bluetooth device has been previously paired to the speaker
it should automatically reconnect when speaker is powered on.
After 4 seconds the speaker will go into connecting mode. This is
indicated by the LED (B) blinking steady. Once the previously paired
®
Bluetooth device is recognized and connected, the LED will go
solid. If connection does not occur and you are unable to stream
music please follow the instructions for Pairing Speaker with a
®
Bluetooth Audio Device.
ADJUSTING THE SPEAKER VOLUME (FIG. 7)
The speaker volume can be decreased or increased by using the
corresponding volume buttons (E). Pressing the "VOL +" button
increases the volume. Pressing the "VOL -" decreases the volume.
11
®
device.
®
AUDIO