Note For Printed Wiring Boards And Schematic Diagrams; Waveforms - Sony CDC-X204 Service Manual

3-6. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1 / W or less unless otherwise
4
specified.
• f : internal component.
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
fied by mark 0 or dotted une marque 0 sont critiques
line with mark 0 are criti- pour la sécurité.
Ne les remplacer que par une
cal for safety.
Replace only with part piéce portant le numéro
number specified. spécifié.
• A : B+ Line.
• B : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• CD mechanism section
no mark : CD PLAY
• Main (1/2), (2/2) and Display sections
no mark : FM
( ) : AM
< > : CD PLAY
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY
F
: FM
f
: AM/MW/LW
a
: AUX
• Abbreviation
CND : Canadian model.
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
a : Through hole.
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
C
Q
These are omitted
B E
B E C
These are omitted
E C B
These are omitted
• Abbreviation
CND : Canadian model.

3-7. WAVEFORMS

— Servo Board —
(MODE: CD PLAY)
1
1.2Vp-p
16.9344MHz
IC1 wd (XTAL)
2
1.6Vp-p
IC1 uj (AGCI)
3
Approx. 620mVp-p
od (FEO)
IC1
4
Approx. 200mVp-p
oh (TEO)
IC1
21 21
CDC-R304/X104EE/X204/X304/X444
— Main Board —
1
2.2Vp-p
27MHz
IC501 qs (OSCOUT)
2
1.8Vp-p
32.768kHz
qg (XIN)
IC501
3
0.9Vp-p
0V
q; (XTO)
IC51
0V