Note For Printed Wiring Boards And Schematic Diagrams - Sony CDX-848X Service Manual

Q Q
3 7 6 3 1 5 1 5 0
6-3.

NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

Note on Printed Wiring Board:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : internal component.
f
• : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
T E
L 1 3 9 4 2 2 9 6 5 1 3
w w w
.
http://www.xiaoyu163.com
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• : internal component.
f
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• H : adjustment for repair.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from CD changer controller.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark : CD PLAY
∗
: Impossible to measure
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J
: CD PLAY (ANALOG OUT)
c : CD PLAY (DIGITAL OUT)
x a o u 1 6 3
y
i
http://www.xiaoyu163.com
8 9
• Circuit Boards Location
DIGITAL OUT board
SWITCH board
Q Q
3 7 6 3 1 5 1
c o
.
21 21
2 4 2
9 8
JACK board
MAIN board
LSW board
5 0 8 9 2 4 9 8
m
CDX-848X
9 9
RF board
2 9 9