Remote Control; Fitting Or Replacing The Batteries In The Remote Control - DCS P9i Mk2 User Manual

dCS P8i Mk2 User Guide Guide for Software Issue 2.0x
Data Conversion Systems Ltd. March 2011

Remote Control

Fitting or replacing the Batteries in the Remote Control

For safety reasons, the remote control is supplied with the 3 batteries packed separately. Any
replacement batteries must be type AAA, MN2400 or equivalent alkaline leak-proof batteries.
To open the battery compartment, turn the Remote Control unit over and remove the 2 screws shown
in the figure below using the Allen key supplied. Lift off the battery cover.
To remove discharged batteries, press the + end back against the spring and pull that end out of the
unit. A small key or screwdriver may be used if the battery is a tight fit. Dispose of the discharged
batteries safely, do not put them in the household waste.
To fit a new battery, press the – end (the flat end) against one of the spring contacts in the battery
holder then press the battery into its slot. Battery polarity is indicated on the battery holder and on the
diagram below. Always fit a complete set of 3 new batteries.
To re-assemble the case, fit the battery cover, ensuring the side with the recessed holes is outward.
Replace the 2 screws, do not over-tighten them as this can damage the screw heads and the remote
case. The Remote Control is ready to use.
Page 12
Manual filename: dCS P8i User Guide v2_0x.docx
English version www.dcsltd.co.uk