Yamaha YZ125X1 Owner's Service Manual page 86

REMOVING THE OIL SEAL
• Replace the oil seal when transmis-
sion oil or coolant leaks out from the
water pump housing hole at the bot-
tom.
• Do not reuse the removed bearing
and oil seal.
1. Remove:
• Bearing "1"
2. Remove:
• Oil seal (outside) "1"
• Oil seal (inside) "2"
CHECKING THE IMPELLER SHAFT
1. Inspect:
• Impeller shaft "1"
→
Bend/wear/damage
→
Fur deposits Clean.
CHECKING THE IMPELLER SHAFT
GEAR
1. Inspect:
• Gear teeth "a"
→
Wear/damage Replace.
CHECKING THE BEARING
1. Inspect:
• Bearing
Rotate inner race with a finger.
→
Rough spot/seizure
CHECKING THE OIL SEAL
1. Inspect:
• Oil seal "1"
Wear/damage
INSTALLING THE OIL SEAL
1. Install:
• Oil seal (inside) "1"
• Oil seal (outside) "2"
• Apply the lithium soap base grease
on the oil seal lip.
• Install the oil seal with its manufac-
ture's marks or numbers facing the
right crankcase cover "3".
Replace.
2. Install:
• Bearing "1"
Install the bearing by pressing its out-
er race parallel.
INSTALLING THE IMPELLER
SHAFT
1. Install:
• Impeller shaft "1"
• Take care so that the oil seal lip is
not damaged or the spring does not
Replace.
slip off its position.
• When installing the impeller shaft,
apply the lithium soap base grease
→
Replace.
4-31
WATER PUMP
on the oil seal lip and impeller shaft.
And install the shaft while turning it.
2. Install:
• Washer "1"
• Dowel pin "2"
• Impeller shaft gear "3"
• Collar "4"
• Washer "5"
• Circlip "6"
Install the Impeller shaft gear with the
dowel pin fitted in the groove "a" in
the same gear.
3. Install:
• Dowel pin "1"
• Gasket (water pump housing cov-
er) "2"
4. Install:
• Water pump housing cover "1"
• Bolt (water pump housing cover)
"2"
Bolt (water pump hous-
ing cover):
10 Nm (1.0 m•kg, 7.2
ft•lb)
• Copper washer (coolant drain
bolt) "3"
• Coolant drain bolt "4"
Coolant drain bolt:
10 Nm (1.0 m•kg, 7.2
ft•lb)