PEUGEOT 306 2002 Owner's Manual page 45

68
YOUR 306 IN DETAIL
GENERAL FUNCTIONS
On / off
With the ignition key in the ACCESSORIES or IGNITION position, press the "M" button to switch the set on or off.
The set can operate for 30 minutes without switching the ignition on.
ANTI-THEFT SYSTEM
The first time you use the set following disconnection of the set or the battery, you must enter the confidential code
which was given to you on handover of your vehicle.
Entering the code
Switch the set on.
The display shows "CODE IN" then the set changes over to code request mode and "- - - -" is displayed.
Enter your four-digit code number using buttons "1" to "6".
For example: if your code is 5345 press buttons "5", "3", "4" and "5" in turn.
When the fourth number has been entered correctly, the radio starts automatically.
Error in entering the code
If an error is made when entering one of the first three digits, do not continue the operation and switch off the radio
to prevent blocking it.
Each incorrect code entry will result in the set being blocked for a period of from 5 seconds to 30 minutes, after
the 7th incorrect entry.
To unblock the set, leave it switched on during the waiting period. When "- - - -" is displayed, you can enter the
code again.
If the set is switched off during the waiting period, this waiting period will restart when the set is switched on again.
After 14 incorrectly input codes, the radio will be permanently locked and will display "END".
ADJUSTING THE SOUND
Adjusting the volume
Turn the "ON/VOL" button M to increase or decrease the volume of the set.
In the event of the radio overheating, the volume level decreases.
Note
If you have a telephone fitted with a "mute" signal output connected to the set, the set will automatically change
to "mute" when the telephone is used.