Soleus Air WM1-05M-01 Operating Instructions Manual page 10

ASSEMBLY & INSTALLATION (CONT.)
IF AC is Blocked by a Storm Window
A storm window frame will not allow the air conditioner to
tilt properly which in turn will keep it from draining properly.
To adjust for this, attach a board or piece of wood to the
sill. The board or wood piece should have a depth of at
least 1 1/2". Make sure the board or piece of wood is ap-
proximately 1/2" higher than the storm window frame. This
will allow the air conditioner to tilt enough for proper drain-
age. (See FIG. 4).
FIG. 4
STORM
1 1/2" MIN
WINDOW
(38 mm)
FRAME
Note:
1. All supporting parts must be secured to firmed wood,
masonry, or metal
2. The air conditioner can be installed without the cur
ns to fit in a narrow window opening.
3. The electric outlet must be within reach of the power
cord.
SASH
Board or wood
piece must be
approximately
1/2" higher
than the storm
window frame
for proper
drainage
Removing the Air Conditioner from the
Window
1. Turn the air conditioner off, and disconnect the power
cord.
2. Remove the sash seal from between windows, and
unscrew sash lock.
3. Remove the screws installed through the frame and
frame lock.
4. Close (slide) the side panels into frame.
5. Keeping a firm grip on air conditioner, raise the sash
and carefully "rock" air conditioner backward to drain
any condensate water in base of unit. Be careful not to
spill any remaining water while lifting unit from window.
6. Store parts with the air conditioner in the box.
-
9