Troubleshooting - HearthRite HR18MN-1 Owner's Operation And Installation Manual

OBSERVED PROBLEM
Burner(s) does not light after
ODS/pilot is lit.
Delayed ignition of burner(s).
Burner backfiring during combustion.
Burner plaque(s) does not glow.
Slight smoke or odor during
initial operation.
Heater produces clicking/ticking
noise just after burner is lit or
shut off.
White powder residue forming within
burner box or on adjacent
walls or furniture.

TROUBLESHOOTING

Continued
POSSIBLE CAUSE
1. Burner orifice is clogged.
2. Burner orifice diameter is too small.
3. Inlet gas pressure is too low.
1. Manifold pressure is too low.
2. Burner orifice is clogged.
1. Burner orifice is clogged
damaged.
2. Burner is damaged.
3. Gas regulator is defective.
1. Plaque is damaged.
2. Inlet gas pressure is too low.
3. Control knob set between locked
positions.
1. Residues from manufacturing
processes.
1. Metal is expanding while heating
or contracting while cooling.
1. When heated the vapors
furniture polish, wax, carpet
cleaners, etc. turn into white
powder residue.
15
REMEDY
1. Clean burner orifice (see Cleaning
and Maintenance, Page 13) or
replace burner orifice.
2. Replace burner orifice.
3. Contact local natural gas company.
1. Contact local natural gas company.
2. Clean burner (see Cleaning and
Maintenance , Page 13) or replace
burner orifice.
or
1. Clean burner orifice (see Cleaning
and Maintenance, Page 13) or
replace.
2. Replace burner.
3. Replace gas regulator.
1. Replace burner.
2. Contact local natural gas company.
3. Turn control knob until it locks at
desired setting.
1. Problem will stop after a few hours
of operation.
1. This is
heaters. if noise
contact qualified service person.
from
1. Turn heater
furniture
cleaner or similar products.
common with most
is excessive,
off when using
polish, wax. carpet