Process Technology DTS Setting Manual page 2

Set the Switch Off time. Scroll to find
5.
the correct hour ( h button) and minute( m
button). Note the AM/PM indicators in
the top left of the LCD.
To set a new cycle, beginning with
6.
Switch On time, press
repeat steps 2-5.
To end programming, slide Controller
Run Mode Switch from
Press P to scroll through cycles
To verify all of your cycles are set
1.
properly, slide the Controller Run Mode
Switch to .
Press repeatedly to scroll settings.
2.
Make changes as needed. When
3.
finished, slide the Controller Run Mode
.
Switch to
Run
Clear Settings
Clear (erase) all settings by pressing
button (reset) at any time. To clear one
setting, continue to step 1.
Slide Controller Run Mode Switch to
1.
Press button to display the Switch
2.
On setting. The arrows at the top and the
time should indicate day of the week and
time of Switch On.
Press the button until no arrows
1...7
3.
display at the top of the LCD.
Press button to display the
4.
corresponding Switch Off setting. Repeat
step 3 for Switch Off.
After clearing the cycle (Switch On
5.
Switch Off settings) slide the Controller
Run Mode Switch to
Wiring
Line Supply
220-240V
50/60Hz
Suitably
Protected
Figure 2: DTS Wiring
M-38-05
Revision – Date: 00 – 05/07/08
button and
.
to
Run
R
and
.
Run
To Control Circuit
Common
220-240V
16AMP
Resistive
AutoRun enables programmed cycles to
run without any additional input.
Slide Controller Run Mode Switch to
1.
.
Run
Slide AutoRun Mode Switch to
2.
DTS immediately goes into AutoRun mode
and will Switch On at next programmed
time.
Override AutoRun
You can temporarily override the AutoRun
setting the following ways:
Override ON:
. Switch remains on indefinitely.
to
I
Override OFF:
. Switch remains off
Switch to
0
indefinitely.
Skip Cycle:
button. The next calendar day is skipped.
If the LCD displays EEE, an error exists in
.
one or more switch cycles.
Slide Controller Run Mode Switch to .
1.
Note the cycle number in error (number
2.
displays with EEE on LCD). Press
button to display settings.
Review settings and fix the error.
3.
Slide the Controller Run Mode Switch to
4.
.
Run
Contact Information
U.S./Canada: (800) 621-1998
7010 Lindsay Dr.
Mentor, OH 44060 U.S.A.
Phone: (440) 974-1300
Fax: (440) 974-9561
2
AutoRun
Slide AutoRun Mode Switch
Slide AutoRun Mode
From AutoRun mode, press
EEE Error
DTS 220-240V Manual
.
Auto