Process Technology DTS Setting Manual

DTS
Digital Timer (220-240V)
The DTS Digital Timer provides versatile, reliable switching control in an easy-to-program
LCD controller capable of setting up to eight switch cycles. A NiCad battery backup saves
settings temporarily during AC power failure; relays are de-energized with loss of AC power.
Set the Clock
The top of the DTS has two slide setting
1.
controls. The Controller Run Mode Switch
is on the right. Slide the Controller Run
Mode Switch to
Numbers printed across the top of the
2.
LCD represent days of the week. Press the
button until the arrow at the top of
1...7
the LCD screen points to the current day.
See details in Figure 1.
Scroll to find the correct hour (
3.
and minute( button). Note the AM/PM
m
indicators in the top left of the LCD.
Scroll.
Press and hold
scroll hours/minutes and set times.
When finished, slide the Controller Run
4.
Mode Switch from
Program a Cycle
Once you set the clock, you can begin
programming switch cycles. DTS has pre-
programmed groups that make it easy to
program a group of days using only one
Cycle. The following groups are available:
Mon-Fri (1-5)
Mon-Sat (1-6)
Note.
Two settings are required per cycle,
Switch On & Switch Off, so eight cycles are
possible. An example of a cycle is Mon–Fri,
Switch On 9am, Switch Off 6pm (Switch
On=relays energized, circuit closed; Switch
Off=circuit open.)
M-38-05
Revision – Date: 00 – 05/07/08
.
button)
h
h m
button/ button to
.
to
Run
Mon-Sun (1-7)
Sat-Sun (6-7)
Set Switch On/Switch Off Times
Slide the Controller Run Mode Switch to
1.
to set Switch On time. A
during Switch On setting. A number
displays just beneath the
switch cycle. When you begin
programming,
1
Numbers printed across the top of the
2.
LCD represent days of the week. Press the
button until the arrow at the top of
1...7
the LCD screen points to the correct day
or group of days (see Figure 1 for details).
Set the Switch On time. Scroll to find
3.
the correct hour ( h button) and minute( m
button). Note the AM/PM indicators in
the top left of the LCD.
Complete the cycle by setting the Switch
4.
Off time. Press
indicating Switch Off and the switch cycle
number changes to
to select the day of the week (the same
day(s) as step 2) .
Figure 1: DTS
1
displays
to identify the
should display.
button. disappears
. Press
button
2 1...7
DTS 220-240V Manual