Set-Up Menu - Sony KLV-52Z450A Operating Instructions Manual

x.v.Colour
Photo Colour Space

Set-up menu

Press MENU and select "Settings". Press
Auto Start-up
Language
AV Set-up
30
GB
Displays moving pictures that is more faithful to the original source by matching the
colour space of source.
• The setting is fixed to "Normal" when the input signal is HDMI (RGB), even if
"x.v.Colour" is selected.
• Only available for HDMI 1, HDMI 2, HDMI 3 and Component in format 720p,
1080i or 1080p.
Selects an option (sRGB, sYCC, Adobe RGB) to set the picture quality best suited
to the colour space of the photograph.
If equipment converts the output colour space of a photograph from sYCC or Adobe
RGB to x.v.Colour or xvYCC, select "sYCC". Results in picture quality best suited
to the original colour space.
If an RGB signal is being input through HDMI input, automatically set to "sRGB"
even if you have selected "sYCC".
• Select "sYCC" when using the equipment that supports "x.v.Colour."
• Only available for HDMI 1, HDMI 2, HDMI 3 and Component input sources.
• Not available when "Colour Space" is set to "Wide" (page 27).
F/f
to select the "Set-up" icon (
Starts the initial set-up procedure.
Usually, you do not need to do this operation because it was done when the TV was
first installed (page 6).
However, this option allows you to repeat the process (e.g. to retune the TV after
moving house, or to search for new channels that have been launched by
broadcasters).
Selects the language in which the menus are displayed.
Video Labels
Assigns a name to any equipment connected to the side and rear jacks. The name will
be displayed briefly on the screen when the equipment is selected. You can skip input
signals from connected equipment that you do not want displayed on the screen.
F f
1 Press
/ to select the desired input source, then press
F f
2 Press / to select the desired option below, then press
Equipment labels: Uses one of the preset labels to assign a name to connected
equipment.
"Edit": Creates your own label. Follow steps 2 to 4 of "Programme Labels" (page 34).
"Skip": Skips an unnecessary input source.
Auto S Video
Selects the input signal from S video jack
connected.
"On": Switches automatically between the S video jack and the composite video
jacks depending on the cable connection.
"Off": Activates the composite video jacks.
.
), then press
.
.
1 when / 1 jacks are both