Docking stereo speaker for ipod and iphone (14 pages)
Summary of Contents for Jensen JiMS-205i
Page 1
® DOCKING MUSIC SYSTEM FOR iPod and iPhone OWNER’S MANUAL JiMS-205i (iPod/iPho ne Not Included) PLEASE READ THIS OPERATING MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
You should note the serial number of this unit in the space provided as a permanent record of your purchase to aid in identification in the event of theft of loss. odel Number: JiMS-205i Serial Number:...
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference.
IMPORTANT NOTES Avoid installing the unit in locations described below: • Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. • Places subject to constant vibration. • Dusty, humid or moist places. COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules.
'feet' before you place the product on fine wooden furniture. PRODUCT FEATURES The JiMS-205i is an iPod/iPhone Docking Music System with incorporates the following features: Player / Charger for iPod nano, iPod touch, iPod classic, iPod video and iPhone.
LOCATION OF CONTROLS MAIN UNIT 1. Power On/Standby Button 2. Multi Function Display 3. Remote Control Sensor 4. iPod/iPhone dock 5. Function Button 6. iPod/iPhone Play/Pause Button; Time Check 7. Left Side of Button: Wake Timer Set / Wake Timer ON/OFF Right Side of Button: Clock Set / Memory Set Button 8.
Page 7
10. Clock/MEM Set; Radio Station preset Button 11. DBBS(bass boost) Button 12. Volume Down Button 13. Volume Up Button 14. Sleep Button 15. DC IN Jack 16. AUX IN Jack 17. Composite Video out Jack 18. FM Antenna 19. Battery Compartment REMOTE CONTROL Power ON / Standby Button iPod/iPhone Play/Pause...
Volume Down Button Volume Up Button INSTALLATION BACKUP BATTERY FOR CLOCK This unit requires a 3V ”CR2032” battery(included) for the clock ,radio preset and alarm memory back up. To active the clock backup function, remove the insulation tab inserted in the battery compartment. To change the battery proceed as follows 1.
NOTE: This unit is not magnetically shielded and may cause color distortion on the screen of some TVs or video monitors. To avoid this, you may need to move the unit further away from the TV or monitor if unnatural color shifts or image distortion occurs.
When the unit is set to standby mode: Setting 12/24 Hour format 1.) Press and hold the RIGHT side of the CLOCK/MEMORY button until the hour digit flashes. Press the LEFT side of the CLOCK/MEMORY button to switch between 12 and 24 hour format. 2.) After a few seconds, the Hour digit will flash again to prompt for input.
Page 11
automatic tuning. If the automatic tuning does not stop on the exact frequency of the station, for example, it stops on 100.9 MHz instead of 100.8 MHz, use the manual tuning method to "fine tune" to the exact frequency of the desired station. If a station is broadcasting in Stereo, the unit will automatically receive the stereo broadcast.
2. Press and hold the FUNCTION button until the flashing “USA”, “JAP”, “EU”, “AUS” or hOA is seen. 3. Repeatedly press the buttons to select one of the broadcasting systems. 4. Press the FUNCTION button to save the setting and exit the setting mode. NOTE: 1.
2.) Press the POWER ON/STANDBY button to turn on the unit. 3.) Press the FUNCTION button repeatedly to select iPod mode. The iPod/iPhone will start playing automatically and start charging immediately. You can also play the iPod/iPhone by pressing iPod/iPhone PLAY/PAUSE button when the unit is at another mode.
Page 14
The sleep timer allows you to turn the unit off after a designated time is reached. 1.) To activate the sleep timer, turn the unit on and either dock your iPod/iPhone or tune to the desired radio station. 2.) Press the SLEEP button and the SLEEP icon appears on the display.
pressed and the unit will reset itself for the following day. 9.) To stop the wake timer after the preset time is reached and the source begins to play, press either the POWER button or the LEFT side of the CLOCK/MEMORY button once.
furniture, Use caution when cleaning and wiping the plastic parts. If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish sprays on the cabinet. If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft cloth slightly dampened with a mild soap and water solution.
If you are using an external sound source like older generation of iPod, try reducing the output volume on the device itself. Also try turning bass boost OFF or change the EQ setting. Unit gets warm after extended Turn the unit off for a period of time or lower This is normal.
Page 18
90 DAY LIMITED WARRANTY AND SERVICE VALID IN THE U.S.A ONLY SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from defective materials or factory workmanship for a period of 90 days from the date of original customer purchase and provided the product is utilized within the U.S.A. This warranty is not assignable or transferable.
Page 19
service representative may need to contact you regarding the status of your repair, so please include your name, address, phone number and email address to expedite the process. IF THE UNIT IS OUTSIDE THE WARRANTY PERIOD, please include a check for $35.00 to cover the cost of repair, handling and return postage.
Need help?
Do you have a question about the JiMS-205i and is the answer not in the manual?
Questions and answers