Table of Contents
Advertisement
Options
Early Dial
Default is "No". Use only if proxy supports 484 response
Dial
Plan
Sets the prefix added to each dialed number
Prefix
No Key
Default is 4 seconds. This is the time lapse after entering a phone number for the IPPH 202 to begin
Entry
completing your call.
Timeout
This parameter allows users to configure the "#" keyto be used as the "Send / Enter" (or "Dial") key. If
Use # as
set to "Yes", pressing this key will immediately trigger the sending of dialed numbers entered thus far.
Dial Key
In this case, this key is essentially equivalent to the "(Re)Dial" key. If set to "No", this "#"key will then
be included as part of the dial string to be sent out.
Auto
Default is NO. When set to yes the phone will automatically pick up
Answer
the call and turn the speaker on.
Voice Mail
This parameter defines the User ID (or extension number) of a 3rd
party voice mail system where the user may have an account. By
Voice Mail
defining this Voice Mail extension, when the user presses the
UserID
"Message" button on the phone, an INVITE message will be sent to
that extension to allow the user to retrieve messages.
This parameter allows users to configure a User ID or extension number to be automatically dialed upon
Off-hook
off-hook. Please note that only the user part of a SIP address needs to be entered here. The IPPH 202
Auto-Dial
will automatically append the "@" and the host portion of the corresponding SIP address.
Enable Call
Default is "No". If set to "Yes", Call Forwarding & Do-Not-Disturb are supported locally
Features
Disable Call
Default is "No".
Waiting
Default
The user can setup up one number on each of the ring tones 1, 2 and 3. When a call is received from one
Ring Tone
of these numbers, the respective ring tone will be generated.
Other Settings:
Meaning
Advertisement
Table of Contents
