Sony GV-D1000E Service Manual page 3

Checking supplied accessories.
Make sure that the following accessories are supplied with your camcorder.
AC power adaptor (1)
(AC-L10A)
0 1-475-599-11
USB cable (1) Wireless Remote Commander (1)
1-757-293-11 RMT-811
1-475-950-21
Lid, Battery Case (for RMT-811)
3-053-056-01
Other accessories
3-071-571-11 MANUAL, INSTRUCTION (ENGLISH/RUSSIAN)
3-071-571-21 MANUAL, INSTRUCTION (FRENCH/SPANISH) (AEP)
3-071-571-31 MANUAL, INSTRUCTION (GERMAN/DUTCH) (AEP)
3-071-571-41 MANUAL, INSTRUCTION (ITALIAN/PORTUGUESE) (AEP)
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH
MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
1. Check the area of your repair for unsoldered or poorly-soldered
connections. Check the entire board surface for solder splashes
and bridges.
2. Check the interboard wiring to ensure that no wires are
"pinched" or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particularly
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
Power cord (Mains lead)(1) (AEP model)
0 1-769-608-11
Power cord (Mains lead)(1) (UK model)
0 1-783-374-11
SAFETY CHECK-OUT
A/V converting cable (1.5m) (1)
1-790-690-11
Size R6 (AA) battery for
Remote Commander (2)
(not supplied)
The components identified by mark 0 or dotted
Note :
line with mark 0 are critical for safety.
Replace only with part number specified.
CAUTION :
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
4. Look for parts which, through functioning, show obvious signs
of deterioration. Point them out to the customer and
recommend their replacement.
5. Check the B+ voltage to see it is at the values specified.
6. Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
— 3 —
GV-D1000E
A/V connecting cable
(1.5m) (1)
1-757-334-11
CD-ROM 21-pin adaptor (1)
(SPVD-008 1-573-291-11
USB Driver)(1)
3-072-414-01