Direct Entry - RCA CRK76 Programming Instructions Manual

Programming Your Remote
3. Point the remote at the component. Press and release PLAY, then wait 5 seconds or
until the indicator on the remote stops flashing.
At this point the remote is searching for the correct code to program. If, after 5
seconds, the component you want to operate does not turn off, press PLAY again to
tell the remote to search the next set of codes.
Continue pressing PLAY until the component turns off or you have searched through
all of the codes. There are 20 total sets of codes. If the component does not turn off
after pressing PLAY 20 times, then the remote cannot can't be programmed to operate
that component.
If the component you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step until the device turns
back ON.
2. To finish, press and hold STOP until the indicator on the remote turns off.

Direct Entry

1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the code list in this
section.
3. Point the remote at the component.
4. Press and hold the component button you want to program on the remote.
5. Enter the 4-digit code from the remote control code list on the following pages. If the
indicator flashes, you have either entered an invalid code or the button isn't
programmable. For example, if your remote came with your DVD player, you cannot
program the DVD button to control another DVD player.
6. Release the component button, and then press ON•OFF to see if the component
responds to the command. If it doesn't, try pressing the component button and then
ON•OFF again.
• If you get no response, repeat these steps using the next code listed for your brand,
until the component responds to the remote commands.
• If you try all the codes for your component brand and none work, try the automatic
code search method. If automatic code search doesn't find the code, the remote is not
compatible with your component.
2
Important
You must continue pressing
the component button while
you enter the code.
Let's say you have a Zenith
TV. To program the universal
remote to operate the TV
you would:
Press and hold the TV button
while you enter the first
code listed for Zenith in the
TV Codes column.
Release the TV button. Press
ON•OFF to see if the TV
responds. If it doesn't, follow
the same steps, but enter the
second code for Zenith TVs
instead of the first.