Toshiba MD14FN1 Service Manual page 19

NOTE
1. In case of the Idler Arm installation, install as the circled
section of Fig. 2-10-B.
2. In case of the Idler Arm Spring installation, install as the
circled section of Fig. 2-10-C.
3. In case of the Chassis Spring installation, install as the
circled section of Fig. 2-10-D.
Idler Arm
Main Chassis Ass'y
Main Chassis Ass'y
2-11: FEED MOTOR (Refer to Fig. 2-11-A)
Remove the 2 screws 1.
1.
2. Remove the Feed Motor.
3. Remove the Motor Gear.
DISASSEMBLY INSTRUCTIONS
Main Chassis Ass'y
Fig. 2-10-B
Idler Arm Spring
Fig. 2-10-C
Chassis Spring
Fig. 2-10-D
Motor Gear
Feed Motor
• Screw Torque: 1 ± 0.5kgf•cm
NOTE
1. In case of the Motor Gear installation, check if the value
of the Fig. 2-11-B is correct.
2. When installing the Feed Motor, check if the cable is
positioned as Fig. 2-11-C.
Motor Gear
Feed Motor
B2-4
1 1
Main Chassis Ass'y
6.1 ± 0.1mm
Safety surface for pressing
of the insert.
Main Chassis Ass'y
Feed Motor
Pass the cable
between 2 pins.
Fig. 2-11-A
Fig. 2-11-B
Fig. 2-11-C