Do you have a question about the Graduate II 724 and is the answer not in the manual?
Questions and answers
Chelsey Johnson
May 16, 2025
Singer model 724 how do I thread it. It's way to loopy
1 comments:
Mr. Anderson
May 22, 2025
To thread the Singer Graduate II 724 sewing machine properly and avoid loops, follow these steps:
1. Raise the presser foot – This opens the tension discs so the thread seats correctly.
2. Turn off the machine – For safety and easier handling.
3. Place the spool – Put your thread spool on the spool pin and use the spool cap if needed.
4. Draw thread through the thread guide – Pull the thread from the spool and pass it through the top thread guide.
5. Follow the threading path – Guide the thread down the right side of the tension area, around the bottom, and back up the left side into the take-up lever (ensure the lever is at its highest point).
6. Thread the take-up lever – Pull the thread through the eye of the take-up lever from right to left.
7. Guide down through thread guides – Continue threading down through any remaining guides above the needle.
8. Thread the needle – Pass the thread through the needle from front to back.
9. Bobbin threading – Insert the bobbin into the case with the thread turning in the correct direction (usually counter-clockwise), draw the thread through the slit and under the tension spring.
10. Draw up bobbin thread – Hold the top thread, turn the handwheel toward you to lower and raise the needle, and pull the top thread to bring up the bobbin thread.
11. Pull both threads back – Pull both threads under the presser foot and toward the back of the machine.
To avoid loops: - Make sure the presser foot is up when threading the top thread. - Ensure the thread is correctly in all guides and the tension discs. - Use correct needle and thread types for your fabric. - Check bobbin tension and threading.
Proper threading and tension adjustments are key to avoiding loops.
Need help?
Do you have a question about the Graduate II 724 and is the answer not in the manual?
Questions and answers
Singer model 724 how do I thread it. It's way to loopy
To thread the Singer Graduate II 724 sewing machine properly and avoid loops, follow these steps:
1. Raise the presser foot – This opens the tension discs so the thread seats correctly.
2. Turn off the machine – For safety and easier handling.
3. Place the spool – Put your thread spool on the spool pin and use the spool cap if needed.
4. Draw thread through the thread guide – Pull the thread from the spool and pass it through the top thread guide.
5. Follow the threading path – Guide the thread down the right side of the tension area, around the bottom, and back up the left side into the take-up lever (ensure the lever is at its highest point).
6. Thread the take-up lever – Pull the thread through the eye of the take-up lever from right to left.
7. Guide down through thread guides – Continue threading down through any remaining guides above the needle.
8. Thread the needle – Pass the thread through the needle from front to back.
9. Bobbin threading – Insert the bobbin into the case with the thread turning in the correct direction (usually counter-clockwise), draw the thread through the slit and under the tension spring.
10. Draw up bobbin thread – Hold the top thread, turn the handwheel toward you to lower and raise the needle, and pull the top thread to bring up the bobbin thread.
11. Pull both threads back – Pull both threads under the presser foot and toward the back of the machine.
To avoid loops:
- Make sure the presser foot is up when threading the top thread.
- Ensure the thread is correctly in all guides and the tension discs.
- Use correct needle and thread types for your fabric.
- Check bobbin tension and threading.
Proper threading and tension adjustments are key to avoiding loops.
This answer is automatically generated