CDVI CDV47 User Manual page 13

How to set the unlock parameter
Unlock mode:
There are two unlock modes: 1.power-on- to-unlock(fail secure): unlock mode=0(default)
The code 8010 is used to set the unlock mode
The code 8011 is used to set the unlock mode to 1
Unlock time:
The unlock time can be changed at any time, it can be set from 1 to 99 seconds.The codes
8401 to 8499 are used to set the unlock time to 1~ 99 seconds.
How to set the monitor as a Guard Monitor
A Monitor can be assigned as Guard Unit Monitor; when the Guard Unit Monitor
answers the call, conversation with the guard person is started..
The code number of 8004 is used to set the monitor as a guard unit monitor and 8005 is
used to cancel this function.
How to set the user code for the monitor
Each monitor should be assigned an address in the system, total 32 addresses can be
set using codes 8200 to 8232 to set the addresses of 01 to 32
- please refer to the following table:
Input No. User Code
8201 Code=1
8202 Code=2
8203 Code=3
8204 Code=4
8205 Code=5
8206 Code=6
8207 Code=7
8208 Code=8
8209 Code=9
8210 Code=10
8211 Code=11
2.power-off-to-unlock(fail safe):unlock mode=1.
Input No. User Code
8212 Code=12
8213 Code=13
8213 Code=14
8215 Code=15
8216 Code=16
8217 Code=17
8218 Code=18
8219 Code=19
8220 Code=20
8221 Code=21
8222 Code=22
Input No. User Code
8223 Code=23
8224 Code=24
8225 Code=25
8226 Code=26
8227 Code=27
8228 Code=28
8229 Code=29
8230 Code=30
8231 Code=31
8232 Code=32
-13-