Advertisement
TEST MODE
TEST MODE FOR BASE SECTION
1.
Start-Up
(1)
Start up of the Test mode by the microcomputer ports.
Before power ON, select the microcomputer ports, 36pin(High or Low),60pin-54pin(short or open),59pin-56pin) pi(short or open).
'*" key
"FLASH" key
36pin
60-54pin
59-56pin
mode
initial state
Channel
HIGH
open
open
Usual Mode
open
open
Test Mode
Remote Unit Call
10CH
LOW
short
open
Test Mode
Remote Unit Call
7 CH
open
short
Test Mode
Remote Unit Call (RX MUTE)
6 CH
(2) Start up of the Test mode by operation of Power ON.
1
2
3
4
5
Continue pressing "lNTERCOM/PAGE/FIND"
key.
Supply the power keeping 'l".
Set the TONE/PULSE
switch to PULSE.
Set the TONWPULSE
switch to TONE.
Release "iNTERCOM/PAGE/FI
ND" key.
Test mode will be Remote Unit Call Status. (channel~l
Och)
In case of Test mode in this way, there are several ways to change the usual mode.
a. detect charge
b. turn off the power, retry
2.
The states of test mode
To channel state, press "##" key and then press numerical key(l or 2 or 3 or 4 or 5).
Or,each time you press "SPEAKER" key ,the state No. is increased.
fle Sltue UI lea
IIIUUG
mode
state name
LED
While "REDIAIJP" key is pressed,TX DATA turns on and Tx MUTE turns
1
Remote Unit Call
on.
IN USE
By pressing "PAGE/lNT" key, DTMF is sent (1 ,2,3,,).By pressing
2
Base Unit Call
"REDIAL" key, PULSE dial is sent.
IN USE
(SPEAKER phone)
SPEAKER
Whl
HkUIAUP" k
t t
3
INTERCOM Call
ey IS pressed, I X data tIJrnSon and I X M
on. l;hile an Incoming call is detected, lNUSE_LED blinks anr%l;~"s
PAGE/lNT
is heard.
SPEAKER
4
Remote Unit Call(Hands-
IN USE
Free Talk)
PAGE/lNT
SPEAKER
5
All Call Route Off
(Tx Power Off)
While "REDIAUP" key is pressed,the Dummy Resistor. for Batt. Check
turn on.(Q912 ON)
PAGE/lNT
If AC low is detected,lN USE, PAGWINT and SPEAKER LEDs turn off.
SPEAKER
While an incomming call is detected, lNUSE_LED blinks and"RING"
CHARGE
is heard.
DIAL
-1o-
Advertisement
