Panasonic KX-TG2620CN Operating Instructions Manual page 29

Programming using the direct commands
1
{ 菜单 }
2
Enter the desired feature code.
3
Enter the desired setting code.
L This step may vary depending on the
feature being programmed.
4
{ 决定 } i { 关闭 }
Feature
Date and time
Dial lock
LCD contrast
(Display contrast)
Registration
Ringer tone (Handset)
Ringer volume (Handset)
Set dial mode
Set flash time
Set line mode
Store IP access#
Time adjustment
(Caller ID subscribers only)
*1 The flash time depends on your telephone exchange or host PBX. Consult your PBX
supplier if necessary.
Feature
code
{4}
{3}
{6}
{0}
{2}
{1}
{9}{1}
*1
{9}{2}
*2
{9}{3}
{#}
*3
{8}
Note:
L In the following table:
– < > shows the default setting.
– If "System setting" column is checked,
you do not need to program the same
item using another handset.
L If you make a mistake or enter the wrong
code, press {关闭}, then start again by
pressing {菜单}.
Setting code
(page 18)
(page 22)
{1}–{6}: Level 1–6 <3>
(page 35)
{1}–{3}: Tone <1>–3
{4}–{7}: Melody 1–4
{1}: Low {2}: Medium
{3}: <High> {0}: Off
{1}: Pulse {2}: <Tone>
(page 17)
{1}: <700ms> {2}: 600ms
{3}: 400ms {4}: 300ms
{5}: 250ms {6}: 110ms
{7}: 100ms {8}: 90ms
{1}: <A> {2}: B
(page 31)
{1}: Caller ID[auto]
{0}: <Manual>
Programming
System
setting
r
r
–
–
–
–
r
r
r
–
r
29