Advertisement
Assembly
Your Judge Desk Fan is supplied ready for easy home assembly.
Base assembly
1. Position the Stand Base
2. Secure with the supplied screws (6-8 depending on model/size).
Do not over-tighten the screws.
Blade and guard grille assembly
1. Unscrew the Guard Grille Retaining Ring
by rotating it anti-clockwise.
2. The Front
and Rear
separate the two halves.
3. Position the Rear Guard Grille
ensuring that the locating pegs on the Motor Housing
in the holes in the Rear Guard Grille
4. Screw the Guard Grille Retaining Ring
rotating clockwise to tighten.
5. If necessary remove and discard the PVC sleeve on the Motor Spindle
6. Place the Fan Blade
of the Fan Blade on the drive pin that passes through the Motor Spindle.
7. Screw the Blade Retaining Knob
clockwise, and tighten firmly against the front of the Fan Blade
8. Position the Front Guard Grille
holes in the rims that accept the small nut and bolt (supplied) are in line. Insert
the Bolt through the hole and screw on the Nut
stage.
9. Push both Guard Grille Retaining Clips down into position ensuring that they
engage correctly on the rim of the Guard Grille
10. Fully tighten the Small Nut and Bolt
onto the Base Surround
Guard Grilles are packed nested inside each other,
against the front of the Motor Housing
.
onto the Motor Spindle
onto the Motor Spindle
against the Rear Guard Grille
.
Desk Fan
.
from the front of the Motor Housing
are engaged correctly
firmly onto the Motor Housing
, locating the slot at the back
. Do not fully tighten at this
.
by
.
by rotating it anti-
.
so that the
Advertisement
