Installation; Leveling The Machine; Water Supply Connection; Drain Outlet Connection - Asko W8844XL W Operating Instructions Manual

INSTALLATION

Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
Cosmetic damage must be reported to your dealer within
five days from the date of purchase. After unpacking the
washer, thoroughly check the unit for cosmetic damage.

LEVELING THE MACHINE

It is important that the machine is level to prevent
excessive vibrations during spin cycles. Each foot of the
washer is adjustable, so you can level the washer on any
surface. Once it is level, securely tighten the lock nuts
on the feet to prevent excessive vibration during spin
cycles.

WATER SUPPLY CONNECTION

Since ASKO washers have a built-in heating element,
you only need a cold water inlet. The connection should
be made by someone who is sufficiently skilled. Use
the hose supplied with the washer. (The inlet hose is
marked for correct connection.) The water pressure
must be in the range 15–146 PSI. A valve should be fitted
on the water supply pipe. If a new supply pipe has been
installed for the washer, it should be flushed thoroughly
to remove any foreign particles that might clog the filter
in the fill valve.
20
Be sure to tighten the
lock nuts securely
when you level the
machine.
Customer Care Center, 1-800-898-1879, www.askona.com
NOTE!
If the unit is installed on a second storey, follow local
building codes. We recommend installing a drip pan.

DRAIN OUTLET CONNECTION

The machine is supplied with the outlet hose already
attached. The hose should be extended over a suitable
sink edge or drain pipe at a height of 24" to 36" (610 mm
to 914 mm) above the bottom of the unit. (The lower
height is preferable.) Make sure the hose is not kinked.
24" to 36"
NOTE!
If the hose is extended, the internal diameter of the
coupling must not be less than ½".
WARNING
Do not extend the drain hose higher than 36" (914 mm)
from the bottom of the unit.

ELECTRICAL INSTALLATION

The machine is delivered ready-fitted with a plug and
is intended for connection to an ASKO Dryer, which is
equipped with a matching receptacle. The plug supplied
with the washer can only be used with an ASKO Dryer.
If the washer is used separately or with another dryer, it
must be on a separate 208-240 V single-phase circuit.
If the machine is to be used in a wet area, the supply
must be protected by a residual current device.
As supplied: 208-240 V, 60 Hz, 2000 heating element,15
A timed delayed fuse is required.
WARNING
Connection to a permanently wired supply point must
be made only by a qualified electrician