benza BZ 170 Use And Maintenance Manual page 23

Electric
Table of Contents

Advertisement

Available languages

Available languages

Especially check:
- The insulation of the power cord should be faultless and without any cracks. If the power cord is damaged, an author-
ized distributor should replace it.
WARNING!
Warning: Do not use this appliance without reading this instruction sheets.
- The electric supply connection shall be made by a qualified electrician and comply with
IEC60364-1.
- The Electric supply to this appliance should include either a residual current device that will
interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a device that will
interrupt the earth circuit.
WARNING: This appliance has been designed for use with the cleaning agent supplied or recom-
mended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect
the safety of the appliance.
WARNING: Do not use the appliance within range of persons unless they wear protective clothing.
WARNING: High pressure jets can be dangerous if subject to misuse. The jet must not be directed
at persons, live electrical equipment or the appliance itself.
- Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
- Risk of explosion – Do not spray flammable liquids.
- Disconnect from the electrical power supply before carrying out user maintenance .
- High pressure cleaners shall not be used by children or untrained personnel.
- To ensure appliance safety, use only original spare parts from the manufacturer or approved by
the manufacturer.
WARNING: Water that has flown through backflow preventers is considered to be non-potable.
WARNING: The machine shall be disconnected from its power source during cleaning or mainte-
nance and when replacing parts for mains operated machines by removing the plug from the sock-
et-outlet;
WARNING: High pressure hoses, fittings and couplings are important for safety of the appliance.
Use only hoses, fittings and couplings recommended by the manufacturer.
- Do not use the appliance if a supply cord or important parts of the appliance are damaged, e.g.
safety devices, high pressure hoses, trigger gun.
WARNING: If an extension cord is used, the plug and socket must be of watertight construction.
WARNING: Inadequate extension cords can be dangerous.
- This high pressure washer must not be used at temperatures below 0°C.
WARNING!
- Cord on drums should always be completely unwinded to prevent the cord from overheating. -
If an extension cord is used, the plug and socket must be of watertight construction.
- Inadequate extension cords can be dangerous.
- comply with the below-mentioned requirements for length and cord dimensions.
1.0 mm²
1.5 mm²
2.5 mm²
Power cord connections should be kept dry and off the ground.
- If the power cord is damaged, it must be replaced by the manufacturer or his service agent or
similarly qualified person in order to avoid a hazard.
All keep the machine on a stable and flat surface during operation, handling, transportation and
storage. Sudden overturn of machine will cause injury to body.
In the event of accident or breakdown, switch off the machine immediately. (e.g. contact with
detergent: rinse with an abundance of clean water)
ATTENTION! THROUGH POOR CONDITIONS OF THE ELECTRICAL MAINS, SHORTLY VOLTAGE DROPS CAN
APPEAR WHEN STARTING THE EQUIPMENT. THIS CAN INFLUENCE OTHER EQUIPMENT (EG. BLINKING OF A
LAMP). IF THE MAINS-IMPEDANCE ZMAX < 0.335 OHM, SUCH DISTURBANCES ARE NOT EXPECTED. (IN CASE
OF NEED, YOU MAY CONTACT YOU LOCAL SUPPLY AUTHORITY FOR FURTHER INFORMATION.)
WARNING! ELECTRICAL SHOCK HAZARD
Improper connection of the equipment-grounding conductor can result in a risk of electrical shock. Check with a qualified
electrician or service person if you are unsure if an outlet is properly grounded. DO NOT modify the plug provided with the
appliance to fit an outlet, have a proper outlet installed by a qualified electrician.
max. 12.5 m
max. 20 m
max. 30 m
23
ENGLISH

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents