Tractor Set-Up - Toro LX420 13AX60RG744 Operator's Manual

SECTION 4: TRACTOR SET-UP
Attaching The Steering Wheel
Tools Required
(1) 1/2" socket wrench
1. The hardware for attaching the steering wheel has
been packed within the steering wheel, beneath
steering wheel cap. Carefully pry off the steering
wheel cap and remove the hardware.
2. With the wheels of the tractor pointing straight
forward, place the steering wheel over the steering
shaft.
3. Place the washer (with the cupped side down) over
the steering shaft and secure with the hex bolt. See
Figure 1.
Hex Bolt
Figure 1
4. Place the steering wheel cap over the center of the
steering wheel and push downward until it "clicks"
into place.
Attaching the Battery Cables
Tools Required
(1) 7/16" wrench
NOTE:
already be attached at the factory.
NOTE:
Cap
(+). The negative battery terminal is marked Neg. (–).
• The positive cable (heavy red wire) is secured to
Washer
the positive battery terminal (+) with a carriage bolt
and hex nut at the factory. Make certain that the
rubber boot covers the terminal to help protect it
from corrosion.
• Remove the carriage bolt and hex nut from the
negative cable.
• Remove the black plastic cover, if present, from the
negative battery terminal and attach the negative
Steering Shaft
cable (heavy black wire) to the negative battery
terminal (–) with the bolt and hex nut.
• Make certain the hold-down rod is in position over
the battery, securing it in place. See Figure 2.
NOTE:
shown on top/side of battery, charge the battery as
instructed on page 27 of this manual prior to operating
the tractor.
10
WARNING:
California Proposition 65
Warning: Battery posts, terminals, and
related accessories contain lead and lead
compounds, chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
Your tractor's battery cables may have
The positive battery terminal is marked Pos.
Rubber
Boot
Carriage Bolt
Hex Nut
Figure 2
If the battery is put into service after the date
Hold Down Rod