Table of Contents
Advertisement
CAUTION
-
Do not use or store this product in a location exposed to high or low temperature that exceeds range
of specification or susceptible to rapid temperature changes.
Example:
-
Do not use this product in extremely humid or dusty locations. It is extremely dangerous to use this
product with its interior penetrated by water or any other fluid or conductive dust. If this product
must be used in such an environment, install it on a dust-proof control panel, for example.
-
Avoid using or storing this product in locations subject to shock or vibration that exceeds range of
specification.
-
Do not use this product in the vicinity of devices that generate strong magnetic force or noise. Such
products will cause this product to malfunction.
-
Do not use or store this product in the presence of chemicals.
-
To clean this product, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing or
discoloration of the paint.
-
This product's case may become hot. To avoid being burned, do not touch that section while this
product is in operation or immediately after turning off the power. Avoid installation in a location
where people may come into contact with that section.
-
CONTEC does not provide any guarantee for the integrity of data on storage device.
-
Be sure to disconnect the power cable from the outlet before connecting cables to and disconnecting
cables from the connectors and before configuring hardware settings such as switches.
-
To prevent corruption of files, always shutdown the OS before turning off this product.
-
CONTEC reserves the right to refuse to service a product modified by the user.
-
In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cord immediately and contact your retailer.
-
To connect with peripherals, use a grounded, shielded cable.
-
When transporting the product, implement sufficient countermeasures to prevent the product from
being directly subjected to vibrations and impacts.
-
You cannot clear the BIOS settings of this product. If you change the BIOS settings and become
unable to boot the computer, it will have to be repaired.
-
If the battery needs to be replaced, the product will have to be repaired. In this situation, contact
your retailer.
-
When disposing of used batteries, do so properly as instructed by the local government.
-
Component Life:
(1) Battery---The internal calendar clock and CMOS RAM are backed by a Lithium primary battery.
The backup time at a temperature of 25°C with the power disconnected is 10 years.
DS-380D Series User's manual
- Exposure to direct sun
- In the vicinity of a heat source
1. Introduction
5
Advertisement
Table of Contents
