Sony STR-DH100 Service Manual page 17

THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : Parts extracted from the component side.
• f : internal component.
• : Pattern from the side which enables seeing.
Caution:
Parts face side: Parts on the parts face side seen from
(SIDE A) the parts face are indicated.
Pattern face side: Parts on the pattern face side seen
(SIDE B) from the pattern face are indicated.
• Abbreviation
CND : Canadian model
STR-DH100
For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
1
• All resistors are in Ω and
/ 4 W or less unless otherwise
specifi ed.
• f : internal component.
• 2 : nonfl ammable resistor.
• 5 : fusible resistor.
• C : panel designation.
Note: Note:
The components identi- Les composants identifi és
fi ed by mark 0 or dotted par une marque 0 sont
line with mark 0 are critiques pour la sécurité.
critical for safety. Ne les remplacer que par
Replace only with part une piéce portant le nu-
number specifi ed. méro spécifi é.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
• Voltages are taken with VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
: TUNER (FM/AM)
F
: VIDEO (AUDIO)
L
I : VIDEO
: DVD (DIGITAL)
J
: CD (ANALOG)
c
• Abbreviation
CND : Canadian model
17 17
STR-DH100