Bosch SGV68U53UC Operating Instructions Manual page 17

Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
1 Press the IOn/Off] button.
2 Hold down the "A" button (see page 15) and press [Start] until the display indicates "H:0x"
(x can be any number).
3 Release both buttons.
4 Press the "A" button until the display shows "r:05".
5 Press the "C" button to select the desired setting.
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:()4" = medium/high setting
"r:05" = high setting
"r:()6" = highest setting
6 Press [Start] to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Press the IOn/Off] button.
2 Press the [+] button until the display jumps to "h:0:l.".
3 Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4 Press [Start] to activate delay start.
To cancel delay start:
1 Press the [+] or [-] button until "h:00" is indicated on the digital display.
2 Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
Auto Power Off
To save energy, the dishwasher is turned off I minute after the wash cycle ends. Auto Power Off can be
adjusted from P:00 to P:02.
To change the setting:
1 Press the IOn/Off] button.
2 Hold down the"A" button (see page 15) and press [Start] until the display indicates"H:0×" (x can
be any number).
3 Release both buttons.
4 Press the "A" button until the display indicates "P:0×".
5 Press the "C" button until the display corresponds with your requirements.
P:0() = dishwasher does not turn off automatically
P:01 = dishwasher turns off automatically after 1 minute
P:()2 = dishwasher turns off automatically after 120 minutes (2 hours)
6 Press [Start] to save the setting.
16