SAFETY & PRECAUTION Thank you for purchasing the La LiLi 5 spa from Gulfstream Inc. Please carefully read the instructions before installing the spa. Carefully follow the instructions and your spa will give you years of beauty and service. This product is to be connected to a branch circuit outlet protected by a Class A GROUND FAULT CIRCUIT INTERRUPTER (GFCI), and the GFCI shall be tested regularly for continued protection and correct operation.
SAFETY & PRECAUTION GROUNDING METHODS Because this unit must be connected to a circuit with a ground-fault circuit interrupter (GFCI), DO NOT use a grounding adapter. The use of a grounding adapter is prohibited in Canada by Part I of the Canadian Electrical Code. GROUNDING INSTRUCTIONS This appliance must be plugged into an outlet equipped with a ground-fault circuit interrupter.
IDENTIFY YOUR FOOT-SPA Back Front Storage 1. Water Mixer Control Control Panel 2. Bowl 3. Flip-out Manicure Tray 4. Back Cushion & Massage 5. Wooden Armrest 6. Seat Cushion 7. Jet Mount 8. Drain 9. Adjustable Footrest 10. Drain Control 11.
Page 6
IDENTIFY YOUR FOOT-SPA SEAT OPERATION Reclining 25° Swing out manicure tray to use accessories bowl Armrest can be raised up/down (Swing-out Accessories Bowl Access is Manicure tray can be folded up/down available in the 9622 and 9620-1 chairs.) Chair Sliding SPA DIMENSION 43’’...
FOOT-SPA CLEARANCE WALL CLEARANCE Wall 34.5’’ Distance from center drain to the back of the spa TYPICAL FOOT-SPAS Center Center 60’’ Foot-spa #2 Foot-spa #1 16’’ 16’’ 16’’ 16’’ 28’’ Clearance 60’’ 27’’ 27’’...
INSTALLATIONS Attaching The Seat to The Base Align the seat with the pre-drilled holes on the base, then tightly secure with the nuts and bolts provided. Attach trays or remote stand to armrest with screws provided.
INSTALLATIONS Cleanjet Unit Removal To remove the jet unit from the tub/bowl. To remove the jet unit components. Pull-out Banana Plug then Gently pull out the jet unit from the anchor pegs. turn the top plate counter-clockwise in the arrow direction. Jet Unit Components Plate &...
Page 10
INSTALLATIONS Poly Liner Installation Align the impeller unit onto the anchor pegs and push it onto Fig.1 the base plate as shown in Fig.1 Soft Plastic Liner To remove, gently pull the impeller unit as shown in Fig.2 from the base plate and pierce liner over the drain, then once drained, pull up the plastic liner.
INSTALLATIONS Plumbing Connections 1. Discharge pump may be connected to an existing sink drain or floor drain. It can also pump up to 7 ft high, but this will increase the length of the drain time. The drain connection is at the rear of the unit by a ½” fitting. 2.
Page 12
INSTALLATIONS Typical Discharge Pump Installation Wall GFI Outlet Required Backwater Valve sold separately Existing Drain Pipe Existing ½’’ Hot & Cold Water Supply Backwater valve sold separately ½” Hot & Cold Hoses Floor Typical Gravity Sink (Direct Drain) Wall Installation GFI Outlet Required Gravity Sink 2’’...
OPERATIONS & USE Control Panel Water Mixer Control Hand Spray Drain Control Jet Control 1. To fill water: The foot-spa is provided with a single hot and cold mixing valve located on the front of your spa. This is a pressure balance valve that requires you to lift the handle to start the water flow and to adjust to the temperature that is desired.
OPERATIONS & USE Shiatsu Remote Control Please refer to instruction manual for operations power timing auto programs pause auto neck&shoulder back&waist position upper manual modes lower KNEAD percussion+knead KNEAD FLAP & F LAP UPPER BODY PRESS KNOCK speed MANUAL kneading NECK SHOULDER SPEED...
The use of oil based products can build up in the whirlpool system, causing clogging in the jets. Adherence to the above cleaning will minimize build up. Gulfstream Inc. does not recommend the use of mineral oil based products. TESTING/FLUSHING FOOT SPA After the foot spa has been installed, fill tub with water just above the jets.
CLEANING & MAINTENANCE& USE Cleaning The Magnet Jet (Step by Step) ® - Do not run Cleanjet MAX without water. This will void your warranty - Do not place two wet ends in the same bowl when cleaning Warning the jet’s strong magnets could cause injury (pins your fingers) - Do not attach two wet ends to each other.
8. Each service call from the customer will be assigned a Claim Number. The Claim Number will stay open until the problem is resolved. No dealer or other person has any authority to bind Gulfstream Inc. to changes or additions to this warranty or its products. Accordingly, Gulfstream Inc. Is not responsible for such warranties or representations.
Need help?
Do you have a question about the La LiLi 5 and is the answer not in the manual?
Questions and answers