Cleaning
12
1. Disconnect the power
cord from the shaver.
2. Apply some hand soap
and some water to the
outer foil.
. Rotate the lock ring to
unlock the 0/1 switch.
. Press the 0/1 switch for
more than 2 seconds to
activate the sonic vibration
cleaning mode.
•
or
flash around
randomly.
•
After about 20 seconds,
it will be automatically
turned off, or you can
turn it off by pressing
the 0/1 switch.
. Remove the outer foil
section and press the 0/1
switch for more than 2
seconds to activate the
sonic vibration cleaning
mode and clean it with
running water.
The mark on the
left means suitable
for cleaning under
an open water tap.
Warning
‑ Disconnect the power cord from the shaver
before cleaning it in water to prevent electric shock.
Caution for the sonic vibration cleaning mode
•
Shaving in the sonic vibration cleaning mode may
damage your skin. Turn the shaver off and then on
again to cancel the sonic vibration cleaning mode.
•
Do not place your fingers on the 0/1 switch while
using the shaver. This may cause the shaver to turn
off or enter the sonic vibration cleaning mode.
. Wipe off any drops of
water with a dry cloth.
. Dry the outer foil section
and the shaver
completely.
. Attach the outer foil
section to the shaver.
. Lubricate the shaver.