Electrical Connection - AEG KD91403E User Manual

10.3. Electrical Connection

Electrical installation must be
performed by an electrician qualified in
accordance with the legislation in force.
Before connecting the crockery warmer
to the electric mains, check that the
voltage and frequency of the mains
matches that which is shown on the
rating plate located in the heating block
inside.
The electric connection is made via an
omnipolar switch, which is suitable for
the intensity to be tolerated and which
has a minimum gap of 3mm between
its contacts, which will ensure
disconnection in case of emergency or
when cleaning the crockery warmer.
If a plug is used for the electric
connection, then it must be accessible
after installation.
The connection should include correct
earthing, in compliance with current
norms.
WARNING: THE CROCKERY
WARMER MUST BE EARTHED.
If the flexible supply cable fitted to the
crockery warmer ever needs to be
changed, it should be replaced by an
official After Sales Service, because it
requires special tools.
The manufacturer and retailers do not
accept responsibility for any damage
that may be caused to people, animals
or property if these installation
instructions are not observed.
www.aeg.com
15